ACPI / gpio: Add irq_type when a GPIO is used as an interrupt
When a GPIO is used as an interrupt in ACPI, the irq_type was not
available for device driver.
Make available polarity and triggering information in acpi_find_gpio by
renaming acpi_gpio_info field active_low to polarity and adding triggering
field (edge/level).
For sanity, in gpiolib.c replace info.active_low by
"info.polarity == GPIO_ACTIVE_LOW".
Set the irq_type if necessary in acpi_dev_gpio_irq_get.
Signed-off-by: Christophe Ricard <christophe-h.ricard@st.com>
Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
diff --git a/drivers/gpio/gpiolib.c b/drivers/gpio/gpiolib.c
index 4e4c308..5d8d7ab 100644
--- a/drivers/gpio/gpiolib.c
+++ b/drivers/gpio/gpiolib.c
@@ -1879,7 +1879,7 @@
return desc;
}
- if (info.active_low)
+ if (info.polarity == GPIO_ACTIVE_LOW)
*flags |= GPIO_ACTIVE_LOW;
return desc;
@@ -2217,7 +2217,7 @@
desc = acpi_node_get_gpiod(fwnode, propname, 0, &info);
if (!IS_ERR(desc))
- active_low = info.active_low;
+ active_low = info.polarity == GPIO_ACTIVE_LOW;
}
if (IS_ERR(desc))