ixgbe: fix typo's
Saw typo in one message, so decided to run spell checker.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Tested-by: Phil Schmitt <phillip.j.schmitt@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c b/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c
index fcf8d4e..cd1f893 100644
--- a/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c
+++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c
@@ -146,7 +146,7 @@
{
BUG_ON(!test_bit(__IXGBE_SERVICE_SCHED, &adapter->state));
- /* flush memory to make sure state is correct before next watchog */
+ /* flush memory to make sure state is correct before next watchdog */
smp_mb__before_clear_bit();
clear_bit(__IXGBE_SERVICE_SCHED, &adapter->state);
}
@@ -2156,7 +2156,7 @@
IXGBE_WRITE_REG(hw, IXGBE_EIMC, IXGBE_IRQ_CLEAR_MASK);
/* for NAPI, using EIAM to auto-mask tx/rx interrupt bits on read
- * therefore no explict interrupt disable is necessary */
+ * therefore no explicit interrupt disable is necessary */
eicr = IXGBE_READ_REG(hw, IXGBE_EICR);
if (!eicr) {
/*
@@ -3606,7 +3606,7 @@
static void ixgbe_sfp_link_config(struct ixgbe_adapter *adapter)
{
/*
- * We are assuming the worst case scenerio here, and that
+ * We are assuming the worst case scenario here, and that
* is that an SFP was inserted/removed after the reset
* but before SFP detection was enabled. As such the best
* solution is to just start searching as soon as we start
@@ -3828,7 +3828,7 @@
case IXGBE_ERR_EEPROM_VERSION:
/* We are running on a pre-production device, log a warning */
e_dev_warn("This device is a pre-production adapter/LOM. "
- "Please be aware there may be issuesassociated with "
+ "Please be aware there may be issues associated with "
"your hardware. If you are experiencing problems "
"please contact your Intel or hardware "
"representative who provided you with this "
@@ -5792,9 +5792,9 @@
* @adapter - pointer to the device adapter structure
*
* This function serves two purposes. First it strobes the interrupt lines
- * in order to make certain interrupts are occuring. Secondly it sets the
+ * in order to make certain interrupts are occurring. Secondly it sets the
* bits needed to check for TX hangs. As a result we should immediately
- * determine if a hang has occured.
+ * determine if a hang has occurred.
*/
static void ixgbe_check_hang_subtask(struct ixgbe_adapter *adapter)
{
@@ -7132,7 +7132,7 @@
return -EINVAL;
/* Hardware has to reinitialize queues and interrupts to
- * match packet buffer alignment. Unfortunantly, the
+ * match packet buffer alignment. Unfortunately, the
* hardware is not flexible enough to do this dynamically.
*/
if (netif_running(dev))