at91_ether: convert to net_device_ops
Signed-off-by: Alexander Beregalov <a.beregalov@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/arm/at91_ether.c b/drivers/net/arm/at91_ether.c
index 442938d..7f4bc8a 100644
--- a/drivers/net/arm/at91_ether.c
+++ b/drivers/net/arm/at91_ether.c
@@ -577,7 +577,7 @@
/*
* Enable/Disable promiscuous and multicast modes.
*/
-static void at91ether_set_rx_mode(struct net_device *dev)
+static void at91ether_set_multicast_list(struct net_device *dev)
{
unsigned long cfg;
@@ -808,7 +808,7 @@
/*
* Transmit packet.
*/
-static int at91ether_tx(struct sk_buff *skb, struct net_device *dev)
+static int at91ether_start_xmit(struct sk_buff *skb, struct net_device *dev)
{
struct at91_private *lp = netdev_priv(dev);
@@ -828,7 +828,7 @@
dev->trans_start = jiffies;
} else {
- printk(KERN_ERR "at91_ether.c: at91ether_tx() called, but device is busy!\n");
+ printk(KERN_ERR "at91_ether.c: at91ether_start_xmit() called, but device is busy!\n");
return 1; /* if we return anything but zero, dev.c:1055 calls kfree_skb(skb)
on this skb, he also reports -ENETDOWN and printk's, so either
we free and return(0) or don't free and return 1 */
@@ -965,6 +965,21 @@
}
#endif
+static const struct net_device_ops at91ether_netdev_ops = {
+ .ndo_open = at91ether_open,
+ .ndo_stop = at91ether_close,
+ .ndo_start_xmit = at91ether_start_xmit,
+ .ndo_get_stats = at91ether_stats,
+ .ndo_set_multicast_list = at91ether_set_multicast_list,
+ .ndo_set_mac_address = set_mac_address,
+ .ndo_do_ioctl = at91ether_ioctl,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_change_mtu = eth_change_mtu,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = at91ether_poll_controller,
+#endif
+};
+
/*
* Initialize the ethernet interface
*/
@@ -1005,17 +1020,8 @@
spin_lock_init(&lp->lock);
ether_setup(dev);
- dev->open = at91ether_open;
- dev->stop = at91ether_close;
- dev->hard_start_xmit = at91ether_tx;
- dev->get_stats = at91ether_stats;
- dev->set_multicast_list = at91ether_set_rx_mode;
- dev->set_mac_address = set_mac_address;
+ dev->netdev_ops = &at91ether_netdev_ops;
dev->ethtool_ops = &at91ether_ethtool_ops;
- dev->do_ioctl = at91ether_ioctl;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = at91ether_poll_controller;
-#endif
SET_NETDEV_DEV(dev, &pdev->dev);