[media] radio-keene: set initial frequency
The device was never set to the initial frequency.
Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
diff --git a/drivers/media/radio/radio-keene.c b/drivers/media/radio/radio-keene.c
index 4c9ae76..99da3d4 100644
--- a/drivers/media/radio/radio-keene.c
+++ b/drivers/media/radio/radio-keene.c
@@ -93,7 +93,7 @@
/* If bit 4 is set, then tune to the frequency.
If bit 3 is set, then unmute; if bit 2 is set, then mute.
If bit 1 is set, then enter idle mode; if bit 0 is set,
- then enter transit mode.
+ then enter transmit mode.
*/
radio->buffer[5] = (radio->muted ? 4 : 8) | (play ? 1 : 2) |
(freq ? 0x10 : 0);
@@ -350,7 +350,6 @@
radio->pa = 118;
radio->tx = 0x32;
radio->stereo = true;
- radio->curfreq = 95.16 * FREQ_MUL;
if (hdl->error) {
retval = hdl->error;
@@ -383,6 +382,8 @@
video_set_drvdata(&radio->vdev, radio);
set_bit(V4L2_FL_USE_FH_PRIO, &radio->vdev.flags);
+ keene_cmd_main(radio, 95.16 * FREQ_MUL, false);
+
retval = video_register_device(&radio->vdev, VFL_TYPE_RADIO, -1);
if (retval < 0) {
dev_err(&intf->dev, "could not register video device\n");