wlcore/wl12xx: use a single memory config and reset if using wl127x
Instead of having two memory configuration sets, one for wl127x and
one for wl128x, we can use only one which should be correctly set by
the lower driver.
The wl12xx driver now uses the wl128x memory config by default but
changes it when if it identifies the wl127x chips.
Signed-off-by: Luciano Coelho <coelho@ti.com>
diff --git a/drivers/net/wireless/ti/wlcore/conf.h b/drivers/net/wireless/ti/wlcore/conf.h
index aa2da45..fef0db4 100644
--- a/drivers/net/wireless/ti/wlcore/conf.h
+++ b/drivers/net/wireless/ti/wlcore/conf.h
@@ -1263,8 +1263,7 @@
struct conf_scan_settings scan;
struct conf_sched_scan_settings sched_scan;
struct conf_ht_setting ht;
- struct conf_memory_settings mem_wl127x;
- struct conf_memory_settings mem_wl128x;
+ struct conf_memory_settings mem;
struct conf_fm_coex fm_coex;
struct conf_rx_streaming_settings rx_streaming;
struct conf_fwlog fwlog;