USB: Add MUSB and TUSB support
This patch adds support for MUSB and TUSB controllers
integrated into omap2430 and davinci. It also adds support
for external tusb6010 controller.
Cc: David Brownell <dbrownell@users.sourceforge.net>
Cc: Tony Lindgren <tony@atomide.com>
Signed-off-by: Felipe Balbi <felipe.balbi@nokia.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/include/linux/usb/musb.h b/include/linux/usb/musb.h
new file mode 100644
index 0000000..d325a0d
--- /dev/null
+++ b/include/linux/usb/musb.h
@@ -0,0 +1,70 @@
+/*
+ * This is used to for host and peripheral modes of the driver for
+ * Inventra (Multidrop) Highspeed Dual-Role Controllers: (M)HDRC.
+ *
+ * Board initialization should put one of these into dev->platform_data,
+ * probably on some platform_device named "musb_hdrc". It encapsulates
+ * key configuration differences between boards.
+ */
+
+/* The USB role is defined by the connector used on the board, so long as
+ * standards are being followed. (Developer boards sometimes won't.)
+ */
+enum musb_mode {
+ MUSB_UNDEFINED = 0,
+ MUSB_HOST, /* A or Mini-A connector */
+ MUSB_PERIPHERAL, /* B or Mini-B connector */
+ MUSB_OTG /* Mini-AB connector */
+};
+
+struct clk;
+
+struct musb_hdrc_platform_data {
+ /* MUSB_HOST, MUSB_PERIPHERAL, or MUSB_OTG */
+ u8 mode;
+
+ /* for clk_get() */
+ const char *clock;
+
+ /* (HOST or OTG) switch VBUS on/off */
+ int (*set_vbus)(struct device *dev, int is_on);
+
+ /* (HOST or OTG) mA/2 power supplied on (default = 8mA) */
+ u8 power;
+
+ /* (PERIPHERAL) mA/2 max power consumed (default = 100mA) */
+ u8 min_power;
+
+ /* (HOST or OTG) msec/2 after VBUS on till power good */
+ u8 potpgt;
+
+ /* TBD: chip defaults should probably go someplace else,
+ * e.g. number of tx/rx endpoints, etc
+ */
+ unsigned multipoint:1;
+
+ /* Power the device on or off */
+ int (*set_power)(int state);
+
+ /* Turn device clock on or off */
+ int (*set_clock)(struct clk *clock, int is_on);
+};
+
+
+/* TUSB 6010 support */
+
+#define TUSB6010_OSCCLK_60 16667 /* psec/clk @ 60.0 MHz */
+#define TUSB6010_REFCLK_24 41667 /* psec/clk @ 24.0 MHz XI */
+#define TUSB6010_REFCLK_19 52083 /* psec/clk @ 19.2 MHz CLKIN */
+
+#ifdef CONFIG_ARCH_OMAP2
+
+extern int __init tusb6010_setup_interface(
+ struct musb_hdrc_platform_data *data,
+ unsigned ps_refclk, unsigned waitpin,
+ unsigned async_cs, unsigned sync_cs,
+ unsigned irq, unsigned dmachan);
+
+extern int tusb6010_platform_retime(unsigned is_refclk);
+
+#endif /* OMAP2 */