ath9k_hw: remove baseband rfsilent support
When rfkill is enabled, ath9k_hw unnecessarily configured the baseband to
turn off based on GPIO input, however that code was hardcoded to GPIO 0
instead of ah->rfkill_gpio.
Since ath9k uses software rfkill anyway, this code is completely unnecessary
and should be removed in case anything else ever uses GPIO 0.
Signed-off-by: Felix Fietkau <nbd@openwrt.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/ar5008_phy.c b/drivers/net/wireless/ath/ath9k/ar5008_phy.c
index 059330a..ffcf44a 100644
--- a/drivers/net/wireless/ath/ath9k/ar5008_phy.c
+++ b/drivers/net/wireless/ath/ath9k/ar5008_phy.c
@@ -961,18 +961,6 @@
REG_WRITE(ah, AR_PHY_RFBUS_REQ, 0);
}
-static void ar5008_hw_enable_rfkill(struct ath_hw *ah)
-{
- REG_SET_BIT(ah, AR_GPIO_INPUT_EN_VAL,
- AR_GPIO_INPUT_EN_VAL_RFSILENT_BB);
-
- REG_CLR_BIT(ah, AR_GPIO_INPUT_MUX2,
- AR_GPIO_INPUT_MUX2_RFSILENT);
-
- ath9k_hw_cfg_gpio_input(ah, ah->rfkill_gpio);
- REG_SET_BIT(ah, AR_PHY_TEST, RFSILENT_BB);
-}
-
static void ar5008_restore_chainmask(struct ath_hw *ah)
{
int rx_chainmask = ah->rxchainmask;
@@ -1629,7 +1617,6 @@
priv_ops->set_delta_slope = ar5008_hw_set_delta_slope;
priv_ops->rfbus_req = ar5008_hw_rfbus_req;
priv_ops->rfbus_done = ar5008_hw_rfbus_done;
- priv_ops->enable_rfkill = ar5008_hw_enable_rfkill;
priv_ops->restore_chainmask = ar5008_restore_chainmask;
priv_ops->set_diversity = ar5008_set_diversity;
priv_ops->do_getnf = ar5008_hw_do_getnf;
diff --git a/drivers/net/wireless/ath/ath9k/ar9003_phy.c b/drivers/net/wireless/ath/ath9k/ar9003_phy.c
index 07b44ce..8d60f4f 100644
--- a/drivers/net/wireless/ath/ath9k/ar9003_phy.c
+++ b/drivers/net/wireless/ath/ath9k/ar9003_phy.c
@@ -745,28 +745,6 @@
REG_WRITE(ah, AR_PHY_RFBUS_REQ, 0);
}
-/*
- * Set the interrupt and GPIO values so the ISR can disable RF
- * on a switch signal. Assumes GPIO port and interrupt polarity
- * are set prior to call.
- */
-static void ar9003_hw_enable_rfkill(struct ath_hw *ah)
-{
- /* Connect rfsilent_bb_l to baseband */
- REG_SET_BIT(ah, AR_GPIO_INPUT_EN_VAL,
- AR_GPIO_INPUT_EN_VAL_RFSILENT_BB);
- /* Set input mux for rfsilent_bb_l to GPIO #0 */
- REG_CLR_BIT(ah, AR_GPIO_INPUT_MUX2,
- AR_GPIO_INPUT_MUX2_RFSILENT);
-
- /*
- * Configure the desired GPIO port for input and
- * enable baseband rf silence.
- */
- ath9k_hw_cfg_gpio_input(ah, ah->rfkill_gpio);
- REG_SET_BIT(ah, AR_PHY_TEST, RFSILENT_BB);
-}
-
static void ar9003_hw_set_diversity(struct ath_hw *ah, bool value)
{
u32 v = REG_READ(ah, AR_PHY_CCK_DETECT);
@@ -1203,7 +1181,6 @@
priv_ops->set_delta_slope = ar9003_hw_set_delta_slope;
priv_ops->rfbus_req = ar9003_hw_rfbus_req;
priv_ops->rfbus_done = ar9003_hw_rfbus_done;
- priv_ops->enable_rfkill = ar9003_hw_enable_rfkill;
priv_ops->set_diversity = ar9003_hw_set_diversity;
priv_ops->ani_control = ar9003_hw_ani_control;
priv_ops->do_getnf = ar9003_hw_do_getnf;
diff --git a/drivers/net/wireless/ath/ath9k/hw-ops.h b/drivers/net/wireless/ath/ath9k/hw-ops.h
index 0a4ad34..c8f254f 100644
--- a/drivers/net/wireless/ath/ath9k/hw-ops.h
+++ b/drivers/net/wireless/ath/ath9k/hw-ops.h
@@ -223,11 +223,6 @@
return ath9k_hw_private_ops(ah)->rfbus_done(ah);
}
-static inline void ath9k_enable_rfkill(struct ath_hw *ah)
-{
- return ath9k_hw_private_ops(ah)->enable_rfkill(ah);
-}
-
static inline void ath9k_hw_restore_chainmask(struct ath_hw *ah)
{
if (!ath9k_hw_private_ops(ah)->restore_chainmask)
diff --git a/drivers/net/wireless/ath/ath9k/hw.c b/drivers/net/wireless/ath/ath9k/hw.c
index ddda76f..4b51ed4 100644
--- a/drivers/net/wireless/ath/ath9k/hw.c
+++ b/drivers/net/wireless/ath/ath9k/hw.c
@@ -1385,7 +1385,7 @@
ath9k_hw_init_qos(ah);
if (ah->caps.hw_caps & ATH9K_HW_CAP_RFSILENT)
- ath9k_enable_rfkill(ah);
+ ath9k_hw_cfg_gpio_input(ah, ah->rfkill_gpio);
ath9k_hw_init_global_settings(ah);
diff --git a/drivers/net/wireless/ath/ath9k/hw.h b/drivers/net/wireless/ath/ath9k/hw.h
index 21e37d1..b98053f 100644
--- a/drivers/net/wireless/ath/ath9k/hw.h
+++ b/drivers/net/wireless/ath/ath9k/hw.h
@@ -576,7 +576,6 @@
void (*set_delta_slope)(struct ath_hw *ah, struct ath9k_channel *chan);
bool (*rfbus_req)(struct ath_hw *ah);
void (*rfbus_done)(struct ath_hw *ah);
- void (*enable_rfkill)(struct ath_hw *ah);
void (*restore_chainmask)(struct ath_hw *ah);
void (*set_diversity)(struct ath_hw *ah, bool value);
u32 (*compute_pll_control)(struct ath_hw *ah,