iwlagn: move iwl_suspend / iwl_resume to the transport layer
These flows needs to access the APM and a few other registers that can differ
between different transports.
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-agn.c b/drivers/net/wireless/iwlwifi/iwl-agn.c
index fcbc3b1..660abed 100644
--- a/drivers/net/wireless/iwlwifi/iwl-agn.c
+++ b/drivers/net/wireless/iwlwifi/iwl-agn.c
@@ -1818,7 +1818,7 @@
/* Configure Tx antenna selection based on H/W config */
iwlagn_send_tx_ant_config(priv, priv->cfg->valid_tx_ant);
- if (iwl_is_associated_ctx(ctx) && !priv->wowlan) {
+ if (iwl_is_associated_ctx(ctx) && !priv->shrd->wowlan) {
struct iwl_rxon_cmd *active_rxon =
(struct iwl_rxon_cmd *)&ctx->active;
/* apply any changes in staging */
@@ -1833,7 +1833,7 @@
iwlagn_set_rxon_chain(priv, ctx);
}
- if (!priv->wowlan) {
+ if (!priv->shrd->wowlan) {
/* WoWLAN ucode will not reply in the same way, skip it */
iwl_reset_run_time_calib(priv);
}
@@ -2593,7 +2593,7 @@
iwl_trans_stop_device(trans(priv));
- priv->wowlan = true;
+ priv->shrd->wowlan = true;
ret = iwlagn_load_ucode_wait_alive(priv, &priv->ucode_wowlan,
IWL_UCODE_WOWLAN);
@@ -2693,7 +2693,7 @@
goto out;
error:
- priv->wowlan = false;
+ priv->shrd->wowlan = false;
iwlagn_prepare_restart(priv);
ieee80211_restart_hw(priv->hw);
out:
@@ -2745,7 +2745,7 @@
/* we'll clear ctx->vif during iwlagn_prepare_restart() */
vif = ctx->vif;
- priv->wowlan = false;
+ priv->shrd->wowlan = false;
device_set_wakeup_enable(priv->bus->dev, false);