net/macb: add support for resetting PHY using GPIO
With device tree it is no more possible to reset the PHY at board
level. Furthermore, doing in the driver allow to power down the PHY when
the network interface is no more used.
This reset can't be done at the PHY driver level. The PHY must be able to
answer the to the mii bus scan to let the kernel creating a PHY device.
The patch introduces a new optional property "phy-reset-gpios" inspired
from the one use for the FEC.
Signed-off-by: Gregory CLEMENT <gregory.clement@free-electrons.com>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/Documentation/devicetree/bindings/net/macb.txt b/Documentation/devicetree/bindings/net/macb.txt
index b5d7976..4a7fb6c 100644
--- a/Documentation/devicetree/bindings/net/macb.txt
+++ b/Documentation/devicetree/bindings/net/macb.txt
@@ -19,6 +19,9 @@
Optional elements: 'tx_clk'
- clocks: Phandles to input clocks.
+Optional properties:
+- phy-reset-gpios : Should specify the gpio for phy reset
+
Examples:
macb0: ethernet@fffc4000 {
diff --git a/drivers/net/ethernet/cadence/macb.c b/drivers/net/ethernet/cadence/macb.c
index 169059c..0123646 100644
--- a/drivers/net/ethernet/cadence/macb.c
+++ b/drivers/net/ethernet/cadence/macb.c
@@ -2904,6 +2904,10 @@
else
macb_get_hwaddr(bp);
+ /* Power up the PHY if there is a GPIO reset */
+ bp->reset_gpio = devm_gpiod_get_optional(&bp->pdev->dev, "phy-reset",
+ GPIOD_OUT_HIGH);
+
err = of_get_phy_mode(np);
if (err < 0) {
pdata = dev_get_platdata(&pdev->dev);
@@ -2970,6 +2974,10 @@
mdiobus_unregister(bp->mii_bus);
kfree(bp->mii_bus->irq);
mdiobus_free(bp->mii_bus);
+
+ /* Shutdown the PHY if there is a GPIO reset */
+ gpiod_set_value(bp->reset_gpio, 0);
+
unregister_netdev(dev);
clk_disable_unprepare(bp->tx_clk);
clk_disable_unprepare(bp->hclk);
diff --git a/drivers/net/ethernet/cadence/macb.h b/drivers/net/ethernet/cadence/macb.h
index d83b0db..5c03e81 100644
--- a/drivers/net/ethernet/cadence/macb.h
+++ b/drivers/net/ethernet/cadence/macb.h
@@ -829,6 +829,7 @@
unsigned int dma_burst_length;
phy_interface_t phy_interface;
+ struct gpio_desc *reset_gpio;
/* AT91RM9200 transmit */
struct sk_buff *skb; /* holds skb until xmit interrupt completes */