[MMC] PXA and i.MX: don't avoid sending stop command on error
Always send a stop command at the end of a data transfer. If we avoid
sending the stop command, some cards remain in data transfer mode, and
refuse to accept further read/write commands.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
diff --git a/drivers/mmc/imxmmc.c b/drivers/mmc/imxmmc.c
index 07f36c4..bc27192 100644
--- a/drivers/mmc/imxmmc.c
+++ b/drivers/mmc/imxmmc.c
@@ -529,7 +529,7 @@
data_error = imxmci_finish_data(host, stat);
- if (host->req->stop && (data_error == MMC_ERR_NONE)) {
+ if (host->req->stop) {
imxmci_stop_clock(host);
imxmci_start_cmd(host, host->req->stop, 0);
} else {
diff --git a/drivers/mmc/pxamci.c b/drivers/mmc/pxamci.c
index eb42cb3..15a5caa 100644
--- a/drivers/mmc/pxamci.c
+++ b/drivers/mmc/pxamci.c
@@ -291,7 +291,7 @@
pxamci_disable_irq(host, DATA_TRAN_DONE);
host->data = NULL;
- if (host->mrq->stop && data->error == MMC_ERR_NONE) {
+ if (host->mrq->stop) {
pxamci_stop_clock(host);
pxamci_start_cmd(host, host->mrq->stop, 0);
} else {