gpio: move GPIOD flags outside #ifdef
The GPIOD flags are defined inside the #ifdef CONFIG_GPIOLIB
switch, making the gpiolib stubs fail if these flags are used
by a consumer. This is not correct: the stubs should compile
fine without GPIOLIB.
Reported-by: Ulf Hansson <ulf.hansson@linaro.org>
Reviewed-by: Alexandre Courbot <acourbot@nvidia.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/include/linux/gpio/consumer.h b/include/linux/gpio/consumer.h
index b7ce0c6..c7e17de 100644
--- a/include/linux/gpio/consumer.h
+++ b/include/linux/gpio/consumer.h
@@ -16,8 +16,6 @@
*/
struct gpio_desc;
-#ifdef CONFIG_GPIOLIB
-
#define GPIOD_FLAGS_BIT_DIR_SET BIT(0)
#define GPIOD_FLAGS_BIT_DIR_OUT BIT(1)
#define GPIOD_FLAGS_BIT_DIR_VAL BIT(2)
@@ -34,6 +32,8 @@
GPIOD_FLAGS_BIT_DIR_VAL,
};
+#ifdef CONFIG_GPIOLIB
+
/* Acquire and dispose GPIOs */
struct gpio_desc *__must_check __gpiod_get(struct device *dev,
const char *con_id,