IB/mlx4: Handle FW command interface rev 3
Upcoming firmware introduces command interface revision 3, which
changes the way port capabilities are queried and set. Update the
driver to handle both the new and old command interfaces by adding a
new MLX4_FLAG_OLD_PORT_CMDS that it is set after querying the firmware
interface revision and then using the correct interface based on the
setting of the flag.
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/net/mlx4/fw.h b/drivers/net/mlx4/fw.h
index 2616fa5..296254a 100644
--- a/drivers/net/mlx4/fw.h
+++ b/drivers/net/mlx4/fw.h
@@ -59,13 +59,13 @@
int max_responder_per_qp;
int max_rdma_global;
int local_ca_ack_delay;
- int max_mtu;
- int max_port_width;
- int max_vl;
int num_ports;
- int max_gids;
+ int max_mtu[MLX4_MAX_PORTS + 1];
+ int max_port_width[MLX4_MAX_PORTS + 1];
+ int max_vl[MLX4_MAX_PORTS + 1];
+ int max_gids[MLX4_MAX_PORTS + 1];
+ int max_pkeys[MLX4_MAX_PORTS + 1];
u16 stat_rate_support;
- int max_pkeys;
u32 flags;
int reserved_uars;
int uar_size;