[ARM] 5033/1: Unbreak corgi_ssp by registering ssp drivers earlier.
A lot of stuff in spitz/akita/etc. depends on corgi_ssp to be initialised
early. However corgi_ssp initialisation fails, because at that time pxa*-ssp
devices don't have drivers. Move ssp earlier in the makefile so they are
registered before corgi-ssp.
Also move sleep/suspend and cpu-freq to more logical places
Signed-off-by: Dmitry Baryshkov <dbaryshkov@gmail.com>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
diff --git a/arch/arm/mach-pxa/Makefile b/arch/arm/mach-pxa/Makefile
index 6a83085..0e6d05b 100644
--- a/arch/arm/mach-pxa/Makefile
+++ b/arch/arm/mach-pxa/Makefile
@@ -5,6 +5,13 @@
# Common support (must be linked before board specific support)
obj-y += clock.o devices.o generic.o irq.o dma.o \
time.o gpio.o
+obj-$(CONFIG_PM) += pm.o sleep.o standby.o
+obj-$(CONFIG_CPU_FREQ) += cpu-pxa.o
+
+# Generic drivers that other drivers may depend upon
+obj-$(CONFIG_PXA_SSP) += ssp.o
+
+# SoC-specific code
obj-$(CONFIG_PXA25x) += mfp-pxa2xx.o pxa25x.o
obj-$(CONFIG_PXA27x) += mfp-pxa2xx.o pxa27x.o
obj-$(CONFIG_PXA3xx) += mfp-pxa3xx.o pxa3xx.o smemc.o
@@ -48,11 +55,6 @@
obj-$(CONFIG_LEDS) += $(led-y)
-# Misc features
-obj-$(CONFIG_PM) += pm.o sleep.o standby.o
-obj-$(CONFIG_CPU_FREQ) += cpu-pxa.o
-obj-$(CONFIG_PXA_SSP) += ssp.o
-
ifeq ($(CONFIG_PCI),y)
obj-$(CONFIG_MACH_ARMCORE) += cm-x270-pci.o
endif