net/mlx4_en: Set correct port parameters during device initialization
Set valid port parameters: MTU and flow control configuration when
configuring the port during HW device initialization,
prior to the net device open() being called.
Using invalid parameters (such as all zeros)
could lead to bad firmware behavior.
Signed-off-by: Yevgeny Petrilin <yevgenyp@mellanox.co.il>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/mellanox/mlx4/en_netdev.c b/drivers/net/ethernet/mellanox/mlx4/en_netdev.c
index 926d8aa..a80280e 100644
--- a/drivers/net/ethernet/mellanox/mlx4/en_netdev.c
+++ b/drivers/net/ethernet/mellanox/mlx4/en_netdev.c
@@ -1204,9 +1204,11 @@
en_warn(priv, "Using %d RX rings\n", prof->rx_ring_num);
/* Configure port */
+ mlx4_en_calc_rx_buf(dev);
err = mlx4_SET_PORT_general(mdev->dev, priv->port,
- MLX4_EN_MIN_MTU,
- 0, 0, 0, 0);
+ priv->rx_skb_size + ETH_FCS_LEN,
+ prof->tx_pause, prof->tx_ppp,
+ prof->rx_pause, prof->rx_ppp);
if (err) {
en_err(priv, "Failed setting port general configurations "
"for port %d, with error %d\n", priv->port, err);