mac80211: Fix accounting of multicast frames
Since multicast frames are marked as no-ack, using
IEEE80211_TX_STAT_ACK to check if they have been
successfully transmitted by the driver is incorrect
since a driver can choose to ignore transmission status
for no-ack frames. This results in incorrect accounting
for such frames.
To fix this issue, this patch introduces a new flag
that can be used by drivers to indicate error-free
transmission of no-ack frames.
Signed-off-by: Sujith Manoharan <c_manoha@qca.qualcomm.com>
[add a note about not setting the flag for non-no-ack frames]
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/net/mac80211/status.c b/net/mac80211/status.c
index bb146f3..d64037c 100644
--- a/net/mac80211/status.c
+++ b/net/mac80211/status.c
@@ -664,13 +664,15 @@
struct ieee80211_supported_band *sband;
int retry_count;
int rates_idx;
- bool acked;
+ bool acked, noack_success;
rates_idx = ieee80211_tx_get_rates(hw, info, &retry_count);
sband = hw->wiphy->bands[info->band];
acked = !!(info->flags & IEEE80211_TX_STAT_ACK);
+ noack_success = !!(info->flags & IEEE80211_TX_STAT_NOACK_TRANSMITTED);
+
if (pubsta) {
struct sta_info *sta;
@@ -696,7 +698,7 @@
rate_control_tx_status_noskb(local, sband, sta, info);
}
- if (acked) {
+ if (acked || noack_success) {
local->dot11TransmittedFrameCount++;
if (!pubsta)
local->dot11MulticastTransmittedFrameCount++;
@@ -856,7 +858,8 @@
* Fragments are passed to low-level drivers as separate skbs, so these
* are actually fragments, not frames. Update frame counters only for
* the first fragment of the frame. */
- if (info->flags & IEEE80211_TX_STAT_ACK) {
+ if ((info->flags & IEEE80211_TX_STAT_ACK) ||
+ (info->flags & IEEE80211_TX_STAT_NOACK_TRANSMITTED)) {
if (ieee80211_is_first_frag(hdr->seq_ctrl)) {
local->dot11TransmittedFrameCount++;
if (is_multicast_ether_addr(hdr->addr1))