ixgbe: Clean up interface for firmware commands
Clean up the interface for issuing firmware commands to use a
void * instead of a u32 *. This eliminates a number of casts.
Also clean up ixgbe_host_interface_command in a few other ways,
eliminating comparisons with 0, redundant parens and minor
formatting issues.
Signed-off-by: Mark Rustad <mark.d.rustad@intel.com>
Tested-by: Andrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c b/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c
index a2ca9ef..b8cdff7 100644
--- a/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c
+++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_common.c
@@ -3483,15 +3483,19 @@
* Communicates with the manageability block. On success return 0
* else return IXGBE_ERR_HOST_INTERFACE_COMMAND.
**/
-s32 ixgbe_host_interface_command(struct ixgbe_hw *hw, u32 *buffer,
+s32 ixgbe_host_interface_command(struct ixgbe_hw *hw, void *buffer,
u32 length, u32 timeout,
bool return_data)
{
- u32 hicr, i, bi, fwsts;
u32 hdr_size = sizeof(struct ixgbe_hic_hdr);
+ u32 hicr, i, bi, fwsts;
u16 buf_len, dword_len;
+ union {
+ struct ixgbe_hic_hdr hdr;
+ u32 u32arr[1];
+ } *bp = buffer;
- if (length == 0 || length > IXGBE_HI_MAX_BLOCK_BYTE_LENGTH) {
+ if (!length || length > IXGBE_HI_MAX_BLOCK_BYTE_LENGTH) {
hw_dbg(hw, "Buffer length failure buffersize-%d.\n", length);
return IXGBE_ERR_HOST_INTERFACE_COMMAND;
}
@@ -3502,26 +3506,25 @@
/* Check that the host interface is enabled. */
hicr = IXGBE_READ_REG(hw, IXGBE_HICR);
- if ((hicr & IXGBE_HICR_EN) == 0) {
+ if (!(hicr & IXGBE_HICR_EN)) {
hw_dbg(hw, "IXGBE_HOST_EN bit disabled.\n");
return IXGBE_ERR_HOST_INTERFACE_COMMAND;
}
/* Calculate length in DWORDs. We must be DWORD aligned */
- if ((length % (sizeof(u32))) != 0) {
+ if (length % sizeof(u32)) {
hw_dbg(hw, "Buffer length failure, not aligned to dword");
return IXGBE_ERR_INVALID_ARGUMENT;
}
dword_len = length >> 2;
- /*
- * The device driver writes the relevant command block
+ /* The device driver writes the relevant command block
* into the ram area.
*/
for (i = 0; i < dword_len; i++)
IXGBE_WRITE_REG_ARRAY(hw, IXGBE_FLEX_MNG,
- i, cpu_to_le32(buffer[i]));
+ i, cpu_to_le32(bp->u32arr[i]));
/* Setting this bit tells the ARC that a new command is pending. */
IXGBE_WRITE_REG(hw, IXGBE_HICR, hicr | IXGBE_HICR_C);
@@ -3534,8 +3537,8 @@
}
/* Check command successful completion. */
- if ((timeout != 0 && i == timeout) ||
- (!(IXGBE_READ_REG(hw, IXGBE_HICR) & IXGBE_HICR_SV))) {
+ if ((timeout && i == timeout) ||
+ !(IXGBE_READ_REG(hw, IXGBE_HICR) & IXGBE_HICR_SV)) {
hw_dbg(hw, "Command has failed with no status valid.\n");
return IXGBE_ERR_HOST_INTERFACE_COMMAND;
}
@@ -3548,13 +3551,13 @@
/* first pull in the header so we know the buffer length */
for (bi = 0; bi < dword_len; bi++) {
- buffer[bi] = IXGBE_READ_REG_ARRAY(hw, IXGBE_FLEX_MNG, bi);
- le32_to_cpus(&buffer[bi]);
+ bp->u32arr[bi] = IXGBE_READ_REG_ARRAY(hw, IXGBE_FLEX_MNG, bi);
+ le32_to_cpus(&bp->u32arr[bi]);
}
/* If there is any thing in data position pull it in */
- buf_len = ((struct ixgbe_hic_hdr *)buffer)->buf_len;
- if (buf_len == 0)
+ buf_len = bp->hdr.buf_len;
+ if (!buf_len)
return 0;
if (length < round_up(buf_len, 4) + hdr_size) {
@@ -3565,10 +3568,10 @@
/* Calculate length in DWORDs, add 3 for odd lengths */
dword_len = (buf_len + 3) >> 2;
- /* Pull in the rest of the buffer (bi is where we left off)*/
+ /* Pull in the rest of the buffer (bi is where we left off) */
for (; bi <= dword_len; bi++) {
- buffer[bi] = IXGBE_READ_REG_ARRAY(hw, IXGBE_FLEX_MNG, bi);
- le32_to_cpus(&buffer[bi]);
+ bp->u32arr[bi] = IXGBE_READ_REG_ARRAY(hw, IXGBE_FLEX_MNG, bi);
+ le32_to_cpus(&bp->u32arr[bi]);
}
return 0;
@@ -3612,7 +3615,7 @@
fw_cmd.pad2 = 0;
for (i = 0; i <= FW_CEM_MAX_RETRIES; i++) {
- ret_val = ixgbe_host_interface_command(hw, (u32 *)&fw_cmd,
+ ret_val = ixgbe_host_interface_command(hw, &fw_cmd,
sizeof(fw_cmd),
IXGBE_HI_COMMAND_TIMEOUT,
true);
diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_common.h b/drivers/net/ethernet/intel/ixgbe/ixgbe_common.h
index 2e29015..6f8e6a5 100644
--- a/drivers/net/ethernet/intel/ixgbe/ixgbe_common.h
+++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_common.h
@@ -111,8 +111,8 @@
s32 ixgbe_get_device_caps_generic(struct ixgbe_hw *hw, u16 *device_caps);
s32 ixgbe_set_fw_drv_ver_generic(struct ixgbe_hw *hw, u8 maj, u8 min,
u8 build, u8 ver);
-s32 ixgbe_host_interface_command(struct ixgbe_hw *hw, u32 *buffer,
- u32 length, u32 timeout, bool return_data);
+s32 ixgbe_host_interface_command(struct ixgbe_hw *hw, void *, u32 length,
+ u32 timeout, bool return_data);
void ixgbe_clear_tx_pending(struct ixgbe_hw *hw);
bool ixgbe_mng_present(struct ixgbe_hw *hw);
bool ixgbe_mng_enabled(struct ixgbe_hw *hw);
diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c b/drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c
index 5affac1..65832fa 100644
--- a/drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c
+++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_x550.c
@@ -437,8 +437,7 @@
/* one word */
buffer.length = cpu_to_be16(sizeof(u16));
- status = ixgbe_host_interface_command(hw, (u32 *)&buffer,
- sizeof(buffer),
+ status = ixgbe_host_interface_command(hw, &buffer, sizeof(buffer),
IXGBE_HI_COMMAND_TIMEOUT, false);
if (status)
return status;
@@ -488,7 +487,7 @@
buffer.address = cpu_to_be32((offset + current_word) * 2);
buffer.length = cpu_to_be16(words_to_read * 2);
- status = ixgbe_host_interface_command(hw, (u32 *)&buffer,
+ status = ixgbe_host_interface_command(hw, &buffer,
sizeof(buffer),
IXGBE_HI_COMMAND_TIMEOUT,
false);
@@ -771,8 +770,7 @@
buffer.data = data;
buffer.address = cpu_to_be32(offset * 2);
- status = ixgbe_host_interface_command(hw, (u32 *)&buffer,
- sizeof(buffer),
+ status = ixgbe_host_interface_command(hw, &buffer, sizeof(buffer),
IXGBE_HI_COMMAND_TIMEOUT, false);
return status;
}
@@ -814,8 +812,7 @@
buffer.req.buf_lenl = FW_SHADOW_RAM_DUMP_LEN;
buffer.req.checksum = FW_DEFAULT_CHECKSUM;
- status = ixgbe_host_interface_command(hw, (u32 *)&buffer,
- sizeof(buffer),
+ status = ixgbe_host_interface_command(hw, &buffer, sizeof(buffer),
IXGBE_HI_COMMAND_TIMEOUT, false);
return status;
}
@@ -864,7 +861,7 @@
fw_cmd.hdr.checksum = FW_DEFAULT_CHECKSUM;
fw_cmd.port_number = hw->bus.lan_id;
- status = ixgbe_host_interface_command(hw, (u32 *)&fw_cmd,
+ status = ixgbe_host_interface_command(hw, &fw_cmd,
sizeof(struct ixgbe_hic_disable_rxen),
IXGBE_HI_COMMAND_TIMEOUT, true);