via-rhine: convert to net_device_ops
Convert driver to new net_device_ops. Compile tested only.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/via-rhine.c b/drivers/net/via-rhine.c
index 9a650d0..93b74b7 100644
--- a/drivers/net/via-rhine.c
+++ b/drivers/net/via-rhine.c
@@ -614,6 +614,20 @@
rhine_reload_eeprom(pioaddr, dev);
}
+static const struct net_device_ops rhine_netdev_ops = {
+ .ndo_open = rhine_open,
+ .ndo_stop = rhine_close,
+ .ndo_start_xmit = rhine_start_tx,
+ .ndo_get_stats = rhine_get_stats,
+ .ndo_set_multicast_list = rhine_set_rx_mode,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_do_ioctl = netdev_ioctl,
+ .ndo_tx_timeout = rhine_tx_timeout,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = rhine_poll,
+#endif
+};
+
static int __devinit rhine_init_one(struct pci_dev *pdev,
const struct pci_device_id *ent)
{
@@ -764,18 +778,10 @@
rp->mii_if.reg_num_mask = 0x1f;
/* The chip-specific entries in the device structure. */
- dev->open = rhine_open;
- dev->hard_start_xmit = rhine_start_tx;
- dev->stop = rhine_close;
- dev->get_stats = rhine_get_stats;
- dev->set_multicast_list = rhine_set_rx_mode;
- dev->do_ioctl = netdev_ioctl;
- dev->ethtool_ops = &netdev_ethtool_ops;
- dev->tx_timeout = rhine_tx_timeout;
+ dev->netdev_ops = &rhine_netdev_ops;
+ dev->ethtool_ops = &netdev_ethtool_ops,
dev->watchdog_timeo = TX_TIMEOUT;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = rhine_poll;
-#endif
+
netif_napi_add(dev, &rp->napi, rhine_napipoll, 64);
if (rp->quirks & rqRhineI)