net: bcmgenet: Software reset EPHY after power on
The EPHY on GENET v1->v3 is extremely finicky, and will show occasional
failures based on the timing and reset sequence, ranging from duplicate
packets, to extremely high latencies.
Perform an additional software reset, and re-configuration to make sure it is
in a consistent and working state.
Fixes: 6ac3ce8295e6 ("net: bcmgenet: Remove excessive PHY reset")
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/genet/bcmgenet.c b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
index 1805541..5e3cd76 100644
--- a/drivers/net/ethernet/broadcom/genet/bcmgenet.c
+++ b/drivers/net/ethernet/broadcom/genet/bcmgenet.c
@@ -907,8 +907,10 @@
}
bcmgenet_ext_writel(priv, reg, EXT_EXT_PWR_MGMT);
- if (mode == GENET_POWER_PASSIVE)
+ if (mode == GENET_POWER_PASSIVE) {
bcmgenet_phy_power_set(priv->dev, true);
+ bcmgenet_mii_reset(priv->dev);
+ }
}
/* ioctl handle special commands that are not present in ethtool. */