netxen: fix byte-swapping in tx and rx
Here's the reworked patch.
This cleans up some unnecessary byte-swapping while setting up tx and
interpreting rx desc. The 64 bit rx status data should be converted
to host endian format only once and the macros just need to extract
bitfields.
This saves a spate of interrupts on pseries blades caused by buggy
(non) processing rx status ring.
Signed-off-by: Dhananjay Phadke <dhananjay@netxen.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/netxen/netxen_nic_init.c b/drivers/net/netxen/netxen_nic_init.c
index 5f85ad6..485ff93 100644
--- a/drivers/net/netxen/netxen_nic_init.c
+++ b/drivers/net/netxen/netxen_nic_init.c
@@ -1070,16 +1070,17 @@
{
struct pci_dev *pdev = adapter->pdev;
struct net_device *netdev = adapter->netdev;
- int index = netxen_get_sts_refhandle(desc);
+ u64 sts_data = le64_to_cpu(desc->status_desc_data);
+ int index = netxen_get_sts_refhandle(sts_data);
struct netxen_recv_context *recv_ctx = &(adapter->recv_ctx[ctxid]);
struct netxen_rx_buffer *buffer;
struct sk_buff *skb;
- u32 length = netxen_get_sts_totallength(desc);
+ u32 length = netxen_get_sts_totallength(sts_data);
u32 desc_ctx;
struct netxen_rcv_desc_ctx *rcv_desc;
int ret;
- desc_ctx = netxen_get_sts_type(desc);
+ desc_ctx = netxen_get_sts_type(sts_data);
if (unlikely(desc_ctx >= NUM_RCV_DESC_RINGS)) {
printk("%s: %s Bad Rcv descriptor ring\n",
netxen_nic_driver_name, netdev->name);
@@ -1119,7 +1120,7 @@
skb = (struct sk_buff *)buffer->skb;
if (likely(adapter->rx_csum &&
- netxen_get_sts_status(desc) == STATUS_CKSUM_OK)) {
+ netxen_get_sts_status(sts_data) == STATUS_CKSUM_OK)) {
adapter->stats.csummed++;
skb->ip_summed = CHECKSUM_UNNECESSARY;
} else
@@ -1209,7 +1210,6 @@
break;
}
netxen_process_rcv(adapter, ctxid, desc);
- netxen_clear_sts_owner(desc);
netxen_set_sts_owner(desc, STATUS_OWNER_PHANTOM);
consumer = (consumer + 1) & (adapter->max_rx_desc_count - 1);
count++;