ide: add struct ide_dma_ops (take 3)
Add struct ide_dma_ops and convert core code + drivers to use it.
While at it:
* Drop "ide_" prefix from ->ide_dma_end and ->ide_dma_test_irq methods.
* Drop "ide_" "infixes" from DMA methods.
* au1xxx-ide.c:
- use auide_dma_{test_irq,end}() directly in auide_dma_timeout()
* pdc202xx_old.c:
- drop "old_" "infixes" from DMA methods
* siimage.c:
- add siimage_dma_test_irq() helper
- print SATA warning in siimage_init_one()
* Remove no longer needed ->init_hwif implementations.
v2:
* Changes based on review from Sergei:
- s/siimage_ide_dma_test_irq/siimage_dma_test_irq/
- s/drive->hwif/hwif/ in idefloppy_pc_intr().
- fix patch description w.r.t. au1xxx-ide changes
- fix au1xxx-ide build
- fix naming for cmd64*_dma_ops
- drop "ide_" and "old_" infixes
- s/hpt3xxx_dma_ops/hpt37x_dma_ops/
- s/hpt370x_dma_ops/hpt370_dma_ops/
- use correct DMA ops for HPT302/N, HPT371/N and HPT374
- s/it821x_smart_dma_ops/it821x_pass_through_dma_ops/
v3:
* Two bugs slipped in v2 (noticed by Sergei):
- use correct DMA ops for HPT374 (for real this time)
- handle HPT370/HPT370A properly
Acked-by: Sergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
diff --git a/drivers/ide/ide-tape.c b/drivers/ide/ide-tape.c
index cac14b2..d3d8b8d 100644
--- a/drivers/ide/ide-tape.c
+++ b/drivers/ide/ide-tape.c
@@ -993,7 +993,7 @@
stat = ide_read_status(drive);
if (pc->flags & PC_FLAG_DMA_IN_PROGRESS) {
- if (hwif->ide_dma_end(drive) || (stat & ERR_STAT)) {
+ if (hwif->dma_ops->dma_end(drive) || (stat & ERR_STAT)) {
/*
* A DMA error is sometimes expected. For example,
* if the tape is crossing a filemark during a
@@ -1213,7 +1213,7 @@
#ifdef CONFIG_BLK_DEV_IDEDMA
/* Begin DMA, if necessary */
if (pc->flags & PC_FLAG_DMA_IN_PROGRESS)
- hwif->dma_start(drive);
+ hwif->dma_ops->dma_start(drive);
#endif
/* Send the actual packet */
HWIF(drive)->atapi_output_bytes(drive, pc->c, 12);
@@ -1279,7 +1279,7 @@
ide_dma_off(drive);
}
if ((pc->flags & PC_FLAG_DMA_RECOMMENDED) && drive->using_dma)
- dma_ok = !hwif->dma_setup(drive);
+ dma_ok = !hwif->dma_ops->dma_setup(drive);
ide_pktcmd_tf_load(drive, IDE_TFLAG_NO_SELECT_MASK |
IDE_TFLAG_OUT_DEVICE, bcount, dma_ok);