Bluetooth: Clear HCI_RAW flag when controller becomes configured
When an unconfigured controllers reaches the configured state, it is
important to change the HCI_RAW flag. It indicates to userspace that
the controller is fully operational.
External configuration allows to bring the controller back into an
unconfigured state. In that case make sure HCI_RAW flag is set again.
Signed-off-by: Marcel Holtmann <marcel@holtmann.org>
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
diff --git a/net/bluetooth/hci_core.c b/net/bluetooth/hci_core.c
index c96b96c..b1d423e 100644
--- a/net/bluetooth/hci_core.c
+++ b/net/bluetooth/hci_core.c
@@ -2887,6 +2887,12 @@
*/
mgmt_index_added(hdev);
} else if (test_and_clear_bit(HCI_CONFIG, &hdev->dev_flags)) {
+ /* When the controller is now configured, then it
+ * is important to clear the HCI_RAW flag.
+ */
+ if (!test_bit(HCI_UNCONFIGURED, &hdev->dev_flags))
+ clear_bit(HCI_RAW, &hdev->flags);
+
/* Powering on the controller with HCI_CONFIG set only
* happens with the transition from unconfigured to
* configured. This will send the Index Added event.