| /* |
| * ss.h |
| * |
| * This program is free software; you can redistribute it and/or modify |
| * it under the terms of the GNU General Public License version 2 as |
| * published by the Free Software Foundation. |
| * |
| * The initial developer of the original code is David A. Hinds |
| * <dahinds@users.sourceforge.net>. Portions created by David A. Hinds |
| * are Copyright (C) 1999 David A. Hinds. All Rights Reserved. |
| * |
| * (C) 1999 David A. Hinds |
| */ |
| |
| #ifndef _LINUX_SS_H |
| #define _LINUX_SS_H |
| |
| #include <linux/device.h> |
| #include <linux/sched.h> /* task_struct, completion */ |
| #include <linux/mutex.h> |
| |
| #include <pcmcia/cs_types.h> |
| #include <pcmcia/cs.h> |
| #ifdef CONFIG_CARDBUS |
| #include <linux/pci.h> |
| #endif |
| |
| /* Definitions for card status flags for GetStatus */ |
| #define SS_WRPROT 0x0001 |
| #define SS_CARDLOCK 0x0002 |
| #define SS_EJECTION 0x0004 |
| #define SS_INSERTION 0x0008 |
| #define SS_BATDEAD 0x0010 |
| #define SS_BATWARN 0x0020 |
| #define SS_READY 0x0040 |
| #define SS_DETECT 0x0080 |
| #define SS_POWERON 0x0100 |
| #define SS_GPI 0x0200 |
| #define SS_STSCHG 0x0400 |
| #define SS_CARDBUS 0x0800 |
| #define SS_3VCARD 0x1000 |
| #define SS_XVCARD 0x2000 |
| #define SS_PENDING 0x4000 |
| #define SS_ZVCARD 0x8000 |
| |
| /* InquireSocket capabilities */ |
| #define SS_CAP_PAGE_REGS 0x0001 |
| #define SS_CAP_VIRTUAL_BUS 0x0002 |
| #define SS_CAP_MEM_ALIGN 0x0004 |
| #define SS_CAP_STATIC_MAP 0x0008 |
| #define SS_CAP_PCCARD 0x4000 |
| #define SS_CAP_CARDBUS 0x8000 |
| |
| /* for GetSocket, SetSocket */ |
| typedef struct socket_state_t { |
| u_int flags; |
| u_int csc_mask; |
| u_char Vcc, Vpp; |
| u_char io_irq; |
| } socket_state_t; |
| |
| extern socket_state_t dead_socket; |
| |
| /* Socket configuration flags */ |
| #define SS_PWR_AUTO 0x0010 |
| #define SS_IOCARD 0x0020 |
| #define SS_RESET 0x0040 |
| #define SS_DMA_MODE 0x0080 |
| #define SS_SPKR_ENA 0x0100 |
| #define SS_OUTPUT_ENA 0x0200 |
| |
| /* Flags for I/O port and memory windows */ |
| #define MAP_ACTIVE 0x01 |
| #define MAP_16BIT 0x02 |
| #define MAP_AUTOSZ 0x04 |
| #define MAP_0WS 0x08 |
| #define MAP_WRPROT 0x10 |
| #define MAP_ATTRIB 0x20 |
| #define MAP_USE_WAIT 0x40 |
| #define MAP_PREFETCH 0x80 |
| |
| /* Use this just for bridge windows */ |
| #define MAP_IOSPACE 0x20 |
| |
| /* power hook operations */ |
| #define HOOK_POWER_PRE 0x01 |
| #define HOOK_POWER_POST 0x02 |
| |
| typedef struct pccard_io_map { |
| u_char map; |
| u_char flags; |
| u_short speed; |
| phys_addr_t start, stop; |
| } pccard_io_map; |
| |
| typedef struct pccard_mem_map { |
| u_char map; |
| u_char flags; |
| u_short speed; |
| phys_addr_t static_start; |
| u_int card_start; |
| struct resource *res; |
| } pccard_mem_map; |
| |
| typedef struct io_window_t { |
| u_int InUse, Config; |
| struct resource *res; |
| } io_window_t; |
| |
| /* Maximum number of IO windows per socket */ |
| #define MAX_IO_WIN 2 |
| |
| /* Maximum number of memory windows per socket */ |
| #define MAX_WIN 4 |
| |
| |
| /* |
| * Socket operations. |
| */ |
| struct pcmcia_socket; |
| struct pccard_resource_ops; |
| struct config_t; |
| struct pcmcia_callback; |
| struct user_info_t; |
| |
| struct pccard_operations { |
| int (*init)(struct pcmcia_socket *s); |
| int (*suspend)(struct pcmcia_socket *s); |
| int (*get_status)(struct pcmcia_socket *s, u_int *value); |
| int (*set_socket)(struct pcmcia_socket *s, socket_state_t *state); |
| int (*set_io_map)(struct pcmcia_socket *s, struct pccard_io_map *io); |
| int (*set_mem_map)(struct pcmcia_socket *s, struct pccard_mem_map *mem); |
| }; |
| |
| struct pcmcia_socket { |
| struct module *owner; |
| spinlock_t lock; |
| socket_state_t socket; |
| u_int state; |
| u_short functions; |
| u_short lock_count; |
| pccard_mem_map cis_mem; |
| void __iomem *cis_virt; |
| struct { |
| u_int AssignedIRQ; |
| u_int Config; |
| } irq; |
| io_window_t io[MAX_IO_WIN]; |
| pccard_mem_map win[MAX_WIN]; |
| struct list_head cis_cache; |
| size_t fake_cis_len; |
| u8 *fake_cis; |
| |
| struct list_head socket_list; |
| struct completion socket_released; |
| |
| /* deprecated */ |
| unsigned int sock; /* socket number */ |
| |
| |
| /* socket capabilities */ |
| u_int features; |
| u_int irq_mask; |
| u_int map_size; |
| u_int io_offset; |
| u_int pci_irq; |
| struct pci_dev * cb_dev; |
| |
| |
| /* socket setup is done so resources should be able to be allocated. |
| * Only if set to 1, calls to find_{io,mem}_region are handled, and |
| * insertio events are actually managed by the PCMCIA layer.*/ |
| u8 resource_setup_done:1; |
| |
| /* It's old if resource setup is done using adjust_resource_info() */ |
| u8 resource_setup_old:1; |
| u8 resource_setup_new:1; |
| |
| u8 reserved:5; |
| |
| /* socket operations */ |
| struct pccard_operations * ops; |
| struct pccard_resource_ops * resource_ops; |
| void * resource_data; |
| |
| /* Zoom video behaviour is so chip specific its not worth adding |
| this to _ops */ |
| void (*zoom_video)(struct pcmcia_socket *, |
| int); |
| |
| /* so is power hook */ |
| int (*power_hook)(struct pcmcia_socket *sock, int operation); |
| |
| /* allows tuning the CB bridge before loading driver for the CB card */ |
| #ifdef CONFIG_CARDBUS |
| void (*tune_bridge)(struct pcmcia_socket *sock, struct pci_bus *bus); |
| #endif |
| |
| /* state thread */ |
| struct task_struct *thread; |
| struct completion thread_done; |
| unsigned int thread_events; |
| /* protects socket h/w state */ |
| struct mutex skt_mutex; |
| /* protects thread_events */ |
| spinlock_t thread_lock; |
| |
| /* pcmcia (16-bit) */ |
| struct pcmcia_callback *callback; |
| |
| #if defined(CONFIG_PCMCIA) || defined(CONFIG_PCMCIA_MODULE) |
| /* The following elements refer to 16-bit PCMCIA devices inserted |
| * into the socket */ |
| struct list_head devices_list; |
| |
| /* the number of devices, used only internally and subject to |
| * incorrectness and change */ |
| u8 device_count; |
| |
| /* 16-bit state: */ |
| struct { |
| /* PCMCIA card is present in socket */ |
| u8 present:1; |
| /* "master" ioctl is used */ |
| u8 busy:1; |
| /* pcmcia module is being unloaded */ |
| u8 dead:1; |
| /* a multifunction-device add event is pending */ |
| u8 device_add_pending:1; |
| /* the pending event adds a mfc (1) or pfc (0) */ |
| u8 mfc_pfc:1; |
| |
| u8 reserved:3; |
| } pcmcia_state; |
| |
| |
| /* for adding further pseudo-multifunction devices */ |
| struct work_struct device_add; |
| |
| #ifdef CONFIG_PCMCIA_IOCTL |
| struct user_info_t *user; |
| wait_queue_head_t queue; |
| #endif /* CONFIG_PCMCIA_IOCTL */ |
| #endif /* CONFIG_PCMCIA */ |
| |
| /* cardbus (32-bit) */ |
| #ifdef CONFIG_CARDBUS |
| struct resource * cb_cis_res; |
| void __iomem *cb_cis_virt; |
| #endif /* CONFIG_CARDBUS */ |
| |
| /* socket device */ |
| struct device dev; |
| /* data internal to the socket driver */ |
| void *driver_data; |
| }; |
| |
| |
| /* socket drivers must define the resource operations type they use. There |
| * are three options: |
| * - pccard_static_ops iomem and ioport areas are assigned statically |
| * - pccard_iodyn_ops iomem areas is assigned statically, ioport |
| * areas dynamically |
| * - pccard_nonstatic_ops iomem and ioport areas are assigned dynamically. |
| * If this option is selected, use |
| * "select PCCARD_NONSTATIC" in Kconfig. |
| */ |
| extern struct pccard_resource_ops pccard_static_ops; |
| extern struct pccard_resource_ops pccard_iodyn_ops; |
| extern struct pccard_resource_ops pccard_nonstatic_ops; |
| |
| /* socket drivers are expected to use these callbacks in their .drv struct */ |
| extern int pcmcia_socket_dev_suspend(struct device *dev); |
| extern int pcmcia_socket_dev_resume(struct device *dev); |
| |
| /* socket drivers use this callback in their IRQ handler */ |
| extern void pcmcia_parse_events(struct pcmcia_socket *socket, |
| unsigned int events); |
| |
| /* to register and unregister a socket */ |
| extern int pcmcia_register_socket(struct pcmcia_socket *socket); |
| extern void pcmcia_unregister_socket(struct pcmcia_socket *socket); |
| |
| |
| #endif /* _LINUX_SS_H */ |