can: Documentation: fix parameter name "sample-point"
This patch fixes the name of the parameter to configure the sample point used
in iproute2's ip command. The correct writing is "sample-point" not
"sample_point".
Signed-off-by: Robert Schwebel <r.schwebel@pengutronix.de>
Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
diff --git a/Documentation/networking/can.txt b/Documentation/networking/can.txt
index 0cbe6ec..2fa44cb 100644
--- a/Documentation/networking/can.txt
+++ b/Documentation/networking/can.txt
@@ -1017,7 +1017,7 @@
in case of a bus-off condition after the specified delay time
in milliseconds. By default it's off.
- "bitrate 125000 sample_point 0.875"
+ "bitrate 125000 sample-point 0.875"
Shows the real bit-rate in bits/sec and the sample-point in the
range 0.000..0.999. If the calculation of bit-timing parameters
is enabled in the kernel (CONFIG_CAN_CALC_BITTIMING=y), the