e1000e: comment corrections
Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/e1000e/phy.c b/drivers/net/e1000e/phy.c
index 140b23b..1bc09b2 100644
--- a/drivers/net/e1000e/phy.c
+++ b/drivers/net/e1000e/phy.c
@@ -153,10 +153,10 @@
goto out;
/*
- * If the PHY ID is still unknown, we may have an 82577i
- * without link. We will try again after setting Slow
- * MDIC mode. No harm in trying again in this case since
- * the PHY ID is unknown at this point anyway
+ * If the PHY ID is still unknown, we may have an 82577
+ * without link. We will try again after setting Slow MDIC
+ * mode. No harm in trying again in this case since the PHY
+ * ID is unknown at this point anyway.
*/
ret_val = phy->ops.acquire(hw);
if (ret_val)
@@ -1744,7 +1744,7 @@
* The automatic gain control (agc) normalizes the amplitude of the
* received signal, adjusting for the attenuation produced by the
* cable. By reading the AGC registers, which represent the
- * combination of course and fine gain value, the value can be put
+ * combination of coarse and fine gain value, the value can be put
* into a lookup table to obtain the approximate cable length
* for each channel.
**/
@@ -1769,7 +1769,7 @@
/*
* Getting bits 15:9, which represent the combination of
- * course and fine gain values. The result is a number
+ * coarse and fine gain values. The result is a number
* that can be put into the lookup table to obtain the
* approximate cable length.
*/
@@ -2511,7 +2511,7 @@
ret_val = e1000e_read_phy_reg_mdic(hw, BM_WUC_DATA_OPCODE,
data);
} else {
- /* Read the page 800 value using opcode 0x12 */
+ /* Write the page 800 value using opcode 0x12 */
ret_val = e1000e_write_phy_reg_mdic(hw, BM_WUC_DATA_OPCODE,
*data);
}