blob: 0f1abaefe4decf6c81f7c5d8feefb3b8ee24c9bc [file] [log] [blame]
/*
* linux/include/asm-arm/arch-omap/board-innovator.h
*
* Copyright (C) 2001 RidgeRun, Inc.
*
* This program is free software; you can redistribute it and/or modify it
* under the terms of the GNU General Public License as published by the
* Free Software Foundation; either version 2 of the License, or (at your
* option) any later version.
*
* THIS SOFTWARE IS PROVIDED ``AS IS'' AND ANY EXPRESS OR IMPLIED
* WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
* MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN
* NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
* NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF
* USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON
* ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
* THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
*
* You should have received a copy of the GNU General Public License along
* with this program; if not, write to the Free Software Foundation, Inc.,
* 675 Mass Ave, Cambridge, MA 02139, USA.
*/
#ifndef __ASM_ARCH_OMAP_INNOVATOR_H
#define __ASM_ARCH_OMAP_INNOVATOR_H
#if defined (CONFIG_ARCH_OMAP1510)
#ifndef OMAP_SDRAM_DEVICE
#define OMAP_SDRAM_DEVICE D256M_1X16_4B
#endif
#define OMAP1510P1_IMIF_PRI_VALUE 0x00
#define OMAP1510P1_EMIFS_PRI_VALUE 0x00
#define OMAP1510P1_EMIFF_PRI_VALUE 0x00
/*
* These definitions define an area of FLASH set aside
* for the use of MTD/JFFS2. This is the area of flash
* that a JFFS2 filesystem will reside which is mounted
* at boot with the "root=/dev/mtdblock/0 rw"
* command line option. The flash address used here must
* fall within the legal range defined by rrload for storing
* the filesystem component. This address will be sufficiently
* deep into the overall flash range to avoid the other
* components also stored in flash such as the bootloader,
* the bootloader params, and the kernel.
* The SW2 settings for the map below are:
* 1 off, 2 off, 3 on, 4 off.
*/
/* Intel flash_0, partitioned as expected by rrload */
#define OMAP_FLASH_0_BASE 0xD8000000
#define OMAP_FLASH_0_START 0x00000000
#define OMAP_FLASH_0_SIZE SZ_16M
/* Intel flash_1, used for cramfs or other flash file systems */
#define OMAP_FLASH_1_BASE 0xD9000000
#define OMAP_FLASH_1_START 0x01000000
#define OMAP_FLASH_1_SIZE SZ_16M
#define NR_FPGA_IRQS 24
#define NR_IRQS IH_BOARD_BASE + NR_FPGA_IRQS
#ifndef __ASSEMBLY__
void fpga_write(unsigned char val, int reg);
unsigned char fpga_read(int reg);
#endif
#endif /* CONFIG_ARCH_OMAP1510 */
#if defined (CONFIG_ARCH_OMAP16XX)
/* At OMAP1610 Innovator the Ethernet is directly connected to CS1 */
#define INNOVATOR1610_ETHR_START 0x04000300
#endif /* CONFIG_ARCH_OMAP1610 */
#endif /* __ASM_ARCH_OMAP_INNOVATOR_H */