of: Always use 'struct device.of_node' to get device node pointer.
The following structure elements duplicate the information in
'struct device.of_node' and so are being eliminated. This patch
makes all readers of these elements use device.of_node instead.
(struct of_device *)->node
(struct dev_archdata *)->prom_node (sparc)
(struct dev_archdata *)->of_node (powerpc & microblaze)
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
diff --git a/drivers/spi/mpc52xx_spi.c b/drivers/spi/mpc52xx_spi.c
index cd68f1c..6573233 100644
--- a/drivers/spi/mpc52xx_spi.c
+++ b/drivers/spi/mpc52xx_spi.c
@@ -403,7 +403,7 @@
/* MMIO registers */
dev_dbg(&op->dev, "probing mpc5200 SPI device\n");
- regs = of_iomap(op->node, 0);
+ regs = of_iomap(op->dev.of_node, 0);
if (!regs)
return -ENODEV;
@@ -445,11 +445,11 @@
ms = spi_master_get_devdata(master);
ms->master = master;
ms->regs = regs;
- ms->irq0 = irq_of_parse_and_map(op->node, 0);
- ms->irq1 = irq_of_parse_and_map(op->node, 1);
+ ms->irq0 = irq_of_parse_and_map(op->dev.of_node, 0);
+ ms->irq1 = irq_of_parse_and_map(op->dev.of_node, 1);
ms->state = mpc52xx_spi_fsmstate_idle;
- ms->ipb_freq = mpc5xxx_get_bus_frequency(op->node);
- ms->gpio_cs_count = of_gpio_count(op->node);
+ ms->ipb_freq = mpc5xxx_get_bus_frequency(op->dev.of_node);
+ ms->gpio_cs_count = of_gpio_count(op->dev.of_node);
if (ms->gpio_cs_count > 0) {
master->num_chipselect = ms->gpio_cs_count;
ms->gpio_cs = kmalloc(ms->gpio_cs_count * sizeof(unsigned int),
@@ -460,7 +460,7 @@
}
for (i = 0; i < ms->gpio_cs_count; i++) {
- gpio_cs = of_get_gpio(op->node, i);
+ gpio_cs = of_get_gpio(op->dev.of_node, i);
if (gpio_cs < 0) {
dev_err(&op->dev,
"could not parse the gpio field "
@@ -512,7 +512,7 @@
if (rc)
goto err_register;
- of_register_spi_devices(master, op->node);
+ of_register_spi_devices(master, op->dev.of_node);
dev_info(&ms->master->dev, "registered MPC5200 SPI bus\n");
return rc;