regulator: bcm590xx: fix vbus name
The vbus regulator was not getting its name set. This results
in the sysfs entry being empty. The lack of a bcm590xx_regs[]
table entry also upsets Coverity runs. Add the table entry
so the name gets set properly.
Signed-off-by: Graham Williams <graham.williams@linaro.org>
Acked-by: Matt Porter <mporter@linaro.org>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/drivers/regulator/bcm590xx-regulator.c b/drivers/regulator/bcm590xx-regulator.c
index 57544e2..58ece59 100644
--- a/drivers/regulator/bcm590xx-regulator.c
+++ b/drivers/regulator/bcm590xx-regulator.c
@@ -119,6 +119,10 @@
2900000, 3000000, 3300000,
};
+static const unsigned int ldo_vbus[] = {
+ 5000000,
+};
+
/* DCDC group CSR: supported voltages in microvolts */
static const struct regulator_linear_range dcdc_csr_ranges[] = {
REGULATOR_LINEAR_RANGE(860000, 2, 50, 10000),
@@ -192,6 +196,7 @@
BCM590XX_REG_TABLE(gpldo4, ldo_a_table),
BCM590XX_REG_TABLE(gpldo5, ldo_a_table),
BCM590XX_REG_TABLE(gpldo6, ldo_a_table),
+ BCM590XX_REG_TABLE(vbus, ldo_vbus),
};
struct bcm590xx_reg {