ARM: at91/boards: use -EINVAL for invalid gpio
this will allow to use gpio_is_valid
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Cc: Nicolas Ferre <nicolas.ferre@atmel.com>
diff --git a/arch/arm/mach-at91/board-afeb-9260v1.c b/arch/arm/mach-at91/board-afeb-9260v1.c
index 17fc779..3bb4069 100644
--- a/arch/arm/mach-at91/board-afeb-9260v1.c
+++ b/arch/arm/mach-at91/board-afeb-9260v1.c
@@ -75,6 +75,8 @@
*/
static struct at91_usbh_data __initdata afeb9260_usbh_data = {
.ports = 1,
+ .vbus_pin = {-EINVAL, -EINVAL},
+ .overcurrent_pin= {-EINVAL, -EINVAL},
};
/*
@@ -82,7 +84,7 @@
*/
static struct at91_udc_data __initdata afeb9260_udc_data = {
.vbus_pin = AT91_PIN_PC5,
- .pullup_pin = 0, /* pull-up driven by UDC */
+ .pullup_pin = -EINVAL, /* pull-up driven by UDC */
};
@@ -138,6 +140,7 @@
.bus_width_16 = 0,
.parts = afeb9260_nand_partition,
.num_parts = ARRAY_SIZE(afeb9260_nand_partition),
+ .det_pin = -EINVAL,
};
@@ -149,6 +152,7 @@
.wp_pin = AT91_PIN_PC4,
.slot_b = 1,
.wire4 = 1,
+ .vcc_pin = -EINVAL,
};
@@ -169,6 +173,8 @@
static struct at91_cf_data afeb9260_cf_data = {
.chipselect = 4,
.irq_pin = AT91_PIN_PA6,
+ .det_pin = -EINVAL,
+ .vcc_pin = -EINVAL,
.rst_pin = AT91_PIN_PA7,
.flags = AT91_CF_TRUE_IDE,
};