ARM: at91/boards: use -EINVAL for invalid gpio
this will allow to use gpio_is_valid
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Cc: Nicolas Ferre <nicolas.ferre@atmel.com>
diff --git a/arch/arm/mach-at91/board-sam9260ek.c b/arch/arm/mach-at91/board-sam9260ek.c
index e1b250e..be8233b 100644
--- a/arch/arm/mach-at91/board-sam9260ek.c
+++ b/arch/arm/mach-at91/board-sam9260ek.c
@@ -75,6 +75,8 @@
*/
static struct at91_usbh_data __initdata ek_usbh_data = {
.ports = 2,
+ .vbus_pin = {-EINVAL, -EINVAL},
+ .overcurrent_pin= {-EINVAL, -EINVAL},
};
/*
@@ -82,7 +84,7 @@
*/
static struct at91_udc_data __initdata ek_udc_data = {
.vbus_pin = AT91_PIN_PC5,
- .pullup_pin = 0, /* pull-up driven by UDC */
+ .pullup_pin = -EINVAL, /* pull-up driven by UDC */
};
@@ -176,7 +178,7 @@
static struct atmel_nand_data __initdata ek_nand_data = {
.ale = 21,
.cle = 22,
-// .det_pin = ... not connected
+ .det_pin = -EINVAL,
.rdy_pin = AT91_PIN_PC13,
.enable_pin = AT91_PIN_PC14,
.parts = ek_nand_partition,
@@ -223,9 +225,9 @@
static struct at91_mmc_data __initdata ek_mmc_data = {
.slot_b = 1,
.wire4 = 1,
-// .det_pin = ... not connected
-// .wp_pin = ... not connected
-// .vcc_pin = ... not connected
+ .det_pin = -EINVAL,
+ .wp_pin = -EINVAL,
+ .vcc_pin = -EINVAL,
};