ALSA: ymfpci: Use standard printk helpers
Convert with dev_err() and co from snd_printk(), etc.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
diff --git a/sound/pci/ymfpci/ymfpci_main.c b/sound/pci/ymfpci/ymfpci_main.c
index c7e98ff..81c916a 100644
--- a/sound/pci/ymfpci/ymfpci_main.c
+++ b/sound/pci/ymfpci/ymfpci_main.c
@@ -86,7 +86,9 @@
return 0;
schedule_timeout_uninterruptible(1);
} while (time_before(jiffies, end_time));
- snd_printk(KERN_ERR "codec_ready: codec %i is not ready [0x%x]\n", secondary, snd_ymfpci_readw(chip, reg));
+ dev_err(chip->card->dev,
+ "codec_ready: codec %i is not ready [0x%x]\n",
+ secondary, snd_ymfpci_readw(chip, reg));
return -EBUSY;
}
@@ -319,7 +321,7 @@
ypcm->last_pos = pos;
if (ypcm->period_pos >= ypcm->period_size) {
/*
- printk(KERN_DEBUG
+ dev_dbg(chip->card->dev,
"done - active_bank = 0x%x, start = 0x%x\n",
chip->active_bank,
voice->bank[chip->active_bank].start);
@@ -372,7 +374,7 @@
if (ypcm->period_pos >= ypcm->period_size) {
ypcm->period_pos %= ypcm->period_size;
/*
- printk(KERN_DEBUG
+ dev_dbg(chip->card->dev,
"done - active_bank = 0x%x, start = 0x%x\n",
chip->active_bank,
voice->bank[chip->active_bank].start);
@@ -2067,7 +2069,8 @@
&chip->pci->dev);
if (err >= 0) {
if (chip->dsp_microcode->size != YDSXG_DSPLENGTH) {
- snd_printk(KERN_ERR "DSP microcode has wrong size\n");
+ dev_err(chip->card->dev,
+ "DSP microcode has wrong size\n");
err = -EINVAL;
}
}
@@ -2082,8 +2085,8 @@
&chip->pci->dev);
if (err >= 0) {
if (chip->controller_microcode->size != YDSXG_CTRLLENGTH) {
- snd_printk(KERN_ERR "controller microcode"
- " has wrong size\n");
+ dev_err(chip->card->dev,
+ "controller microcode has wrong size\n");
err = -EINVAL;
}
}
@@ -2360,8 +2363,7 @@
pci_set_power_state(pci, PCI_D0);
pci_restore_state(pci);
if (pci_enable_device(pci) < 0) {
- printk(KERN_ERR "ymfpci: pci_enable_device failed, "
- "disabling device\n");
+ dev_err(dev, "pci_enable_device failed, disabling device\n");
snd_card_disconnect(card);
return -EIO;
}
@@ -2433,13 +2435,15 @@
chip->src441_used = -1;
if ((chip->res_reg_area = request_mem_region(chip->reg_area_phys, 0x8000, "YMFPCI")) == NULL) {
- snd_printk(KERN_ERR "unable to grab memory region 0x%lx-0x%lx\n", chip->reg_area_phys, chip->reg_area_phys + 0x8000 - 1);
+ dev_err(chip->card->dev,
+ "unable to grab memory region 0x%lx-0x%lx\n",
+ chip->reg_area_phys, chip->reg_area_phys + 0x8000 - 1);
snd_ymfpci_free(chip);
return -EBUSY;
}
if (request_irq(pci->irq, snd_ymfpci_interrupt, IRQF_SHARED,
KBUILD_MODNAME, chip)) {
- snd_printk(KERN_ERR "unable to grab IRQ %d\n", pci->irq);
+ dev_err(chip->card->dev, "unable to grab IRQ %d\n", pci->irq);
snd_ymfpci_free(chip);
return -EBUSY;
}
@@ -2453,7 +2457,7 @@
err = snd_ymfpci_request_firmware(chip);
if (err < 0) {
- snd_printk(KERN_ERR "firmware request failed: %d\n", err);
+ dev_err(chip->card->dev, "firmware request failed: %d\n", err);
snd_ymfpci_free(chip);
return err;
}