iwlwifi: mvm: Add device wide power command
FW starts using legacy power table command (0x77) for device wide power
settings. Currently this command contains only option flags field.
It can configure the following: CAM (Continuous Active Mode) and
POWER_SAVE_ENABLE debug option. Send this command when firmware is
loaded - D0 and D3.
Note: Setting this command is important to avoid unwanted FW behavior.
It particularly fixes a bug when a device does not drop to low power
after disassociation from AP.
Signed-off-by: Alexander Bondar <alexander.bondar@intel.com>
Reviewed-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/mvm/d3.c b/drivers/net/wireless/iwlwifi/mvm/d3.c
index d08c12b..ab5c1f0 100644
--- a/drivers/net/wireless/iwlwifi/mvm/d3.c
+++ b/drivers/net/wireless/iwlwifi/mvm/d3.c
@@ -1149,6 +1149,10 @@
if (ret)
goto out;
+ ret = iwl_mvm_power_update_device_mode(mvm);
+ if (ret)
+ goto out;
+
ret = iwl_mvm_power_update_mode(mvm, vif);
if (ret)
goto out;