mtd: nand: fsmc: update of OF support
Add nand bank selection and timings to the device tree bindings.
Signed-off-by: Mian Yousaf Kaukab <mian.yousaf.kaukab@stericsson.com>
[Added some documentation]
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
diff --git a/Documentation/devicetree/bindings/mtd/fsmc-nand.txt b/Documentation/devicetree/bindings/mtd/fsmc-nand.txt
index 2240ac0..ec42935 100644
--- a/Documentation/devicetree/bindings/mtd/fsmc-nand.txt
+++ b/Documentation/devicetree/bindings/mtd/fsmc-nand.txt
@@ -1,4 +1,5 @@
-* FSMC NAND
+ST Microelectronics Flexible Static Memory Controller (FSMC)
+NAND Interface
Required properties:
- compatible : "st,spear600-fsmc-nand", "stericsson,fsmc-nand"
@@ -9,6 +10,26 @@
- bank-width : Width (in bytes) of the device. If not present, the width
defaults to 1 byte
- nand-skip-bbtscan: Indicates the the BBT scanning should be skipped
+- timings: array of 6 bytes for NAND timings. The meanings of these bytes
+ are:
+ byte 0 TCLR : CLE to RE delay in number of AHB clock cycles, only 4 bits
+ are valid. Zero means one clockcycle, 15 means 16 clock
+ cycles.
+ byte 1 TAR : ALE to RE delay, 4 bits are valid. Same format as TCLR.
+ byte 2 THIZ : number of HCLK clock cycles during which the data bus is
+ kept in Hi-Z (tristate) after the start of a write access.
+ Only valid for write transactions. Zero means zero cycles,
+ 255 means 255 cycles.
+ byte 3 THOLD : number of HCLK clock cycles to hold the address (and data
+ when writing) after the command deassertation. Zero means
+ one cycle, 255 means 256 cycles.
+ byte 4 TWAIT : number of HCLK clock cycles to assert the command to the
+ NAND flash in response to SMWAITn. Zero means 1 cycle,
+ 255 means 256 cycles.
+ byte 5 TSET : number of HCLK clock cycles to assert the address before the
+ command is asserted. Zero means one cycle, 255 means 256
+ cycles.
+- bank: default NAND bank to use (0-3 are valid, 0 is the default).
Example:
@@ -24,6 +45,8 @@
bank-width = <1>;
nand-skip-bbtscan;
+ timings = /bits/ 8 <0 0 0 2 3 0>;
+ bank = <1>;
partition@0 {
...