spi: Add Qualcomm QUP SPI controller support
Qualcomm Universal Peripheral (QUP) core is an AHB slave that
provides a common data path (an output FIFO and an input FIFO)
for serial peripheral interface (SPI) mini-core. SPI in master
mode supports up to 50MHz, up to four chip selects, programmable
data path from 4 bits to 32 bits and numerous protocol variants.
Cc: Alok Chauhan <alokc@codeaurora.org>
Cc: Gilad Avidov <gavidov@codeaurora.org>
Cc: Kiran Gunda <kgunda@codeaurora.org>
Cc: Sagar Dharia <sdharia@codeaurora.org>
Cc: dsneddon@codeaurora.org
Signed-off-by: Ivan T. Ivanov <iivanov@mm-sol.com>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig
index ba9310b..86c254d 100644
--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -381,6 +381,19 @@
help
SPI driver for Renesas RSPI blocks.
+config SPI_QUP
+ tristate "Qualcomm SPI controller with QUP interface"
+ depends on ARCH_MSM_DT
+ help
+ Qualcomm Universal Peripheral (QUP) core is an AHB slave that
+ provides a common data path (an output FIFO and an input FIFO)
+ for serial peripheral interface (SPI) mini-core. SPI in master
+ mode supports up to 50MHz, up to four chip selects, programmable
+ data path from 4 bits to 32 bits and numerous protocol variants.
+
+ This driver can also be built as a module. If so, the module
+ will be called spi_qup.
+
config SPI_S3C24XX
tristate "Samsung S3C24XX series SPI"
depends on ARCH_S3C24XX