mei: use hbm idle state to prevent spurious resets
When reset is caused by hbm protocol mismatch or timeout
we might end up in an endless reset loop and hbm protocol
will never sync
Cc: <stable@vger.kernel.org>
Signed-off-by: Tomas Winkler <tomas.winkler@intel.com>
Signed-off-by: Alexander Usyskin <alexander.usyskin@intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/misc/mei/hbm.c b/drivers/misc/mei/hbm.c
index 8109b9a..836f92d 100644
--- a/drivers/misc/mei/hbm.c
+++ b/drivers/misc/mei/hbm.c
@@ -126,6 +126,17 @@
return false;
}
+/**
+ * mei_hbm_idle - set hbm to idle state
+ *
+ * @dev: the device structure
+ */
+void mei_hbm_idle(struct mei_device *dev)
+{
+ dev->init_clients_timer = 0;
+ dev->hbm_state = MEI_HBM_IDLE;
+}
+
int mei_hbm_start_wait(struct mei_device *dev)
{
int ret;
@@ -583,6 +594,14 @@
mei_read_slots(dev, dev->rd_msg_buf, hdr->length);
mei_msg = (struct mei_bus_message *)dev->rd_msg_buf;
+ /* ignore spurious message and prevent reset nesting
+ * hbm is put to idle during system reset
+ */
+ if (dev->hbm_state == MEI_HBM_IDLE) {
+ dev_dbg(&dev->pdev->dev, "hbm: state is idle ignore spurious messages\n");
+ return 0;
+ }
+
switch (mei_msg->hbm_cmd) {
case HOST_START_RES_CMD:
dev_dbg(&dev->pdev->dev, "hbm: start: response message received.\n");