i2c: tegra: use readl_poll_timeout after config_load reg programmed
After CONFIG_LOAD register is programmed instead of explicitly waiting
for timeout, use readl_poll_timeout() to check for register value to get
updated or wait till timeout.
Signed-off-by: Shardar Shariff Md <smohammed@nvidia.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>
diff --git a/drivers/i2c/busses/i2c-tegra.c b/drivers/i2c/busses/i2c-tegra.c
index d86a993..e93c72a 100644
--- a/drivers/i2c/busses/i2c-tegra.c
+++ b/drivers/i2c/busses/i2c-tegra.c
@@ -30,6 +30,7 @@
#include <linux/reset.h>
#include <linux/pinctrl/consumer.h>
#include <linux/pm_runtime.h>
+#include <linux/iopoll.h>
#include <asm/unaligned.h>
@@ -112,6 +113,8 @@
#define I2C_CLKEN_OVERRIDE 0x090
#define I2C_MST_CORE_CLKEN_OVR BIT(0)
+#define I2C_CONFIG_LOAD_TIMEOUT 1000000
+
/*
* msg_end_type: The bus control which need to be send at end of transfer.
* @MSG_END_STOP: Send stop pulse at end of transfer.
@@ -448,7 +451,6 @@
u32 val;
int err;
u32 clk_divisor;
- unsigned long timeout = jiffies + HZ;
err = pm_runtime_get_sync(i2c_dev->dev);
if (err < 0) {
@@ -497,15 +499,18 @@
i2c_writel(i2c_dev, I2C_MST_CORE_CLKEN_OVR, I2C_CLKEN_OVERRIDE);
if (i2c_dev->hw->has_config_load_reg) {
+ unsigned long reg_offset;
+ void __iomem *addr;
+
+ reg_offset = tegra_i2c_reg_addr(i2c_dev, I2C_CONFIG_LOAD);
+ addr = i2c_dev->base + reg_offset;
i2c_writel(i2c_dev, I2C_MSTR_CONFIG_LOAD, I2C_CONFIG_LOAD);
- while (i2c_readl(i2c_dev, I2C_CONFIG_LOAD) != 0) {
- if (time_after(jiffies, timeout)) {
- dev_warn(i2c_dev->dev,
- "timeout waiting for config load\n");
- err = -ETIMEDOUT;
- goto err;
- }
- msleep(1);
+ err = readl_poll_timeout(addr, val, val == 0, 1000,
+ I2C_CONFIG_LOAD_TIMEOUT);
+ if (err) {
+ dev_warn(i2c_dev->dev,
+ "timeout waiting for config load\n");
+ goto err;
}
}