sky2: Yukon Extreme (88e8071) support.
Enable support for Yukon EX chipset (88e8071).
Most of changes are related to new commands to chip for transmit,
and change in status and checksumming.
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/sky2.h b/drivers/net/sky2.h
index c6c0baf..8df4643 100644
--- a/drivers/net/sky2.h
+++ b/drivers/net/sky2.h
@@ -483,6 +483,11 @@
CHIP_REV_YU_FE_A2 = 2,
};
+enum yukon_ex_rev {
+ CHIP_REV_YU_EX_A0 = 1,
+ CHIP_REV_YU_EX_B0 = 2,
+};
+
/* B2_Y2_CLK_GATE 8 bit Clock Gating (Yukon-2 only) */
enum {
@@ -1692,6 +1697,16 @@
RX_VLAN_STRIP_ON = 1<<25, /* enable VLAN stripping */
RX_VLAN_STRIP_OFF = 1<<24, /* disable VLAN stripping */
+ RX_MACSEC_FLUSH_ON = 1<<23,
+ RX_MACSEC_FLUSH_OFF = 1<<22,
+ RX_MACSEC_ASF_FLUSH_ON = 1<<21,
+ RX_MACSEC_ASF_FLUSH_OFF = 1<<20,
+
+ GMF_RX_OVER_ON = 1<<19, /* enable flushing on receive overrun */
+ GMF_RX_OVER_OFF = 1<<18, /* disable flushing on receive overrun */
+ GMF_ASF_RX_OVER_ON = 1<<17, /* enable flushing of ASF when overrun */
+ GMF_ASF_RX_OVER_OFF = 1<<16, /* disable flushing of ASF when overrun */
+
GMF_WP_TST_ON = 1<<14, /* Write Pointer Test On */
GMF_WP_TST_OFF = 1<<13, /* Write Pointer Test Off */
GMF_WP_STEP = 1<<12, /* Write Pointer Step/Increment */
@@ -1804,6 +1819,15 @@
/* GMAC_CTRL 32 bit GMAC Control Reg (YUKON only) */
enum {
+ GMC_SET_RST = 1<<15,/* MAC SEC RST */
+ GMC_SEC_RST_OFF = 1<<14,/* MAC SEC RSt OFF */
+ GMC_BYP_MACSECRX_ON = 1<<13,/* Bypass macsec RX */
+ GMC_BYP_MACSECRX_OFF= 1<<12,/* Bypass macsec RX off */
+ GMC_BYP_MACSECTX_ON = 1<<11,/* Bypass macsec TX */
+ GMC_BYP_MACSECTX_OFF= 1<<10,/* Bypass macsec TX off*/
+ GMC_BYP_RETR_ON = 1<<9, /* Bypass retransmit FIFO On */
+ GMC_BYP_RETR_OFF= 1<<8, /* Bypass retransmit FIFO Off */
+
GMC_H_BURST_ON = 1<<7, /* Half Duplex Burst Mode On */
GMC_H_BURST_OFF = 1<<6, /* Half Duplex Burst Mode Off */
GMC_F_LOOPB_ON = 1<<5, /* FIFO Loopback On */
@@ -1889,9 +1913,13 @@
OP_ADDR64VLAN = OP_ADDR64 | OP_VLAN,
OP_LRGLEN = 0x24,
OP_LRGLENVLAN = OP_LRGLEN | OP_VLAN,
+ OP_MSS = 0x28,
+ OP_MSSVLAN = OP_MSS | OP_VLAN,
+
OP_BUFFER = 0x40,
OP_PACKET = 0x41,
OP_LARGESEND = 0x43,
+ OP_LSOV2 = 0x45,
/* YUKON-2 STATUS opcodes defines */
OP_RXSTAT = 0x60,
@@ -1902,6 +1930,19 @@
OP_RXTIMEVLAN = OP_RXTIMESTAMP | OP_RXVLAN,
OP_RSS_HASH = 0x65,
OP_TXINDEXLE = 0x68,
+ OP_MACSEC = 0x6c,
+ OP_PUTIDX = 0x70,
+};
+
+enum status_css {
+ CSS_TCPUDPCSOK = 1<<7, /* TCP / UDP checksum is ok */
+ CSS_ISUDP = 1<<6, /* packet is a UDP packet */
+ CSS_ISTCP = 1<<5, /* packet is a TCP packet */
+ CSS_ISIPFRAG = 1<<4, /* packet is a TCP/UDP frag, CS calc not done */
+ CSS_ISIPV6 = 1<<3, /* packet is a IPv6 packet */
+ CSS_IPV4CSUMOK = 1<<2, /* IP v4: TCP header checksum is ok */
+ CSS_ISIPV4 = 1<<1, /* packet is a IPv4 packet */
+ CSS_LINK_BIT = 1<<0, /* port number (legacy) */
};
/* Yukon 2 hardware interface */
@@ -1922,7 +1963,7 @@
struct sky2_status_le {
__le32 status; /* also checksum */
__le16 length; /* also vlan tag */
- u8 link;
+ u8 css;
u8 opcode;
} __attribute((packed));