[MTD] [NAND] at91_nand.c: CMDLINE_PARTS support
This patch allows you to specify at91_nand partitions on the
kernel command line using the mtdparts variable, if
CONFIG_MTD_CMDLINE_PARTS is set.
Signed-off-by: Frank Mandarino <fmandarino@endrelia.com>
Signed-off-by: Andrew Victor <andrew@sanpeople.com>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
diff --git a/drivers/mtd/nand/at91_nand.c b/drivers/mtd/nand/at91_nand.c
index 14b80cc..512e999 100644
--- a/drivers/mtd/nand/at91_nand.c
+++ b/drivers/mtd/nand/at91_nand.c
@@ -82,6 +82,10 @@
at91_set_gpio_value(host->board->enable_pin, 1);
}
+#ifdef CONFIG_MTD_PARTITIONS
+const char *part_probes[] = { "cmdlinepart", NULL };
+#endif
+
/*
* Probe for the NAND device.
*/
@@ -151,6 +155,12 @@
#ifdef CONFIG_MTD_PARTITIONS
if (host->board->partition_info)
partitions = host->board->partition_info(mtd->size, &num_partitions);
+#ifdef CONFIG_MTD_CMDLINE_PARTS
+ else {
+ mtd->name = "at91_nand";
+ num_partitions = parse_mtd_partitions(mtd, part_probes, &partitions, 0);
+ }
+#endif
if ((!partitions) || (num_partitions == 0)) {
printk(KERN_ERR "at91_nand: No parititions defined, or unsupported device.\n");