[NET]: move config options out to individual protocols
Move the protocol specific config options out to the specific protocols.
With this change net/Kconfig now starts to become readable and serve as a
good basis for further re-structuring.
The menu structure is left almost intact, except that indention is
fixed in most cases. Most visible are the INET changes where several
"depends on INET" are replaced with a single ifdef INET / endif pair.
Several new files were created to accomplish this change - they are
small but serve the purpose that config options are now distributed
out where they belongs.
Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/ipv6/Kconfig b/net/ipv6/Kconfig
index e66ca93..95163cd 100644
--- a/net/ipv6/Kconfig
+++ b/net/ipv6/Kconfig
@@ -1,6 +1,26 @@
#
# IPv6 configuration
-#
+#
+
+# IPv6 as module will cause a CRASH if you try to unload it
+config IPV6
+ tristate "The IPv6 protocol"
+ default m
+ select CRYPTO if IPV6_PRIVACY
+ select CRYPTO_MD5 if IPV6_PRIVACY
+ ---help---
+ This is complemental support for the IP version 6.
+ You will still be able to do traditional IPv4 networking as well.
+
+ For general information about IPv6, see
+ <http://playground.sun.com/pub/ipng/html/ipng-main.html>.
+ For Linux IPv6 development information, see <http://www.linux-ipv6.org>.
+ For specific information about IPv6 under Linux, read the HOWTO at
+ <http://www.bieringer.de/linux/IPv6/>.
+
+ To compile this protocol support as a module, choose M here: the
+ module will be called ipv6.
+
config IPV6_PRIVACY
bool "IPv6: Privacy Extensions (RFC 3041) support"
depends on IPV6