[B43]: Remove the "radio hw enabled" message on startup.
This message is useless. Only report state changes.
Cc: Larry Finger <larry.finger@lwfinger.net>
Signed-off-by: Michael Buesch <mb@bu3sch.de>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/wireless/b43/main.c b/drivers/net/wireless/b43/main.c
index 1390f41..cc528540 100644
--- a/drivers/net/wireless/b43/main.c
+++ b/drivers/net/wireless/b43/main.c
@@ -2227,9 +2227,6 @@
if (err)
goto err_gpio_cleanup;
b43_radio_turn_on(dev);
- dev->radio_hw_enable = b43_is_hw_radio_enabled(dev);
- b43dbg(dev->wl, "Radio %s by hardware\n",
- dev->radio_hw_enable ? "enabled" : "disabled");
b43_write16(dev, 0x03E6, 0x0000);
err = b43_phy_init(dev);
@@ -3252,6 +3249,9 @@
{
/* Flags */
dev->reg124_set_0x4 = 0;
+ /* Assume the radio is enabled. If it's not enabled, the state will
+ * immediately get fixed on the first periodic work run. */
+ dev->radio_hw_enable = 1;
/* Stats */
memset(&dev->stats, 0, sizeof(dev->stats));