tty: serial: msm: Fix style warnings relating to printk()
fixed below checkpatch.pl warning:
WARNING: Prefer [subsystem eg: netdev]_err([subsystem]dev, ... then dev_err(dev, ... then pr_err(... to printk(KERN_ERR ...
WARNING: Prefer [subsystem eg: netdev]_info([subsystem]dev, ... then dev_info(dev, ... then pr_info(... to printk(KERN_INFO ...
Signed-off-by: Kiran Padwal <kiran.padwal@smartplayin.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/msm_serial.c b/drivers/tty/serial/msm_serial.c
index 0295493..e70d4e8 100644
--- a/drivers/tty/serial/msm_serial.c
+++ b/drivers/tty/serial/msm_serial.c
@@ -677,7 +677,7 @@
clk_disable_unprepare(msm_port->pclk);
break;
default:
- printk(KERN_ERR "msm_serial: Unknown PM state %d\n", state);
+ pr_err("msm_serial: Unknown PM state %d\n", state);
}
}
@@ -957,7 +957,7 @@
msm_write(port, UART_CR_TX_ENABLE, UART_CR);
}
- printk(KERN_INFO "msm_serial: console setup on port #%d\n", port->line);
+ pr_info("msm_serial: console setup on port #%d\n", port->line);
return uart_set_options(port, co, baud, parity, bits, flow);
}
@@ -1012,7 +1012,7 @@
if (unlikely(pdev->id < 0 || pdev->id >= UART_NR))
return -ENXIO;
- printk(KERN_INFO "msm_serial: detected port #%d\n", pdev->id);
+ dev_info(&pdev->dev, "msm_serial: detected port #%d\n", pdev->id);
port = get_port_from_line(pdev->id);
port->dev = &pdev->dev;
@@ -1037,8 +1037,7 @@
}
port->uartclk = clk_get_rate(msm_port->clk);
- printk(KERN_INFO "uartclk = %d\n", port->uartclk);
-
+ dev_info(&pdev->dev, "uartclk = %d\n", port->uartclk);
resource = platform_get_resource(pdev, IORESOURCE_MEM, 0);
if (unlikely(!resource))
@@ -1092,7 +1091,7 @@
if (unlikely(ret))
uart_unregister_driver(&msm_uart_driver);
- printk(KERN_INFO "msm_serial: driver initialized\n");
+ pr_info("msm_serial: driver initialized\n");
return ret;
}