IB/ipath: Fix up error handling
This patch makes chip reset more robust and reduces lock contention
between user and kernel TID register updates.
Signed-off-by: Ralph Campbell <ralph.campbell@qlogic.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/ipath/ipath_iba6120.c b/drivers/infiniband/hw/ipath/ipath_iba6120.c
index 907b61b..c8d8f1a 100644
--- a/drivers/infiniband/hw/ipath/ipath_iba6120.c
+++ b/drivers/infiniband/hw/ipath/ipath_iba6120.c
@@ -558,12 +558,40 @@
dd->ipath_hwerrmask);
}
- if (*msg)
- ipath_dev_err(dd, "%s hardware error\n", msg);
- if (isfatal && !ipath_diag_inuse && dd->ipath_freezemsg) {
+ if (hwerrs) {
/*
- * for /sys status file ; if no trailing } is copied, we'll
- * know it was truncated.
+ * if any set that we aren't ignoring; only
+ * make the complaint once, in case it's stuck
+ * or recurring, and we get here multiple
+ * times.
+ */
+ ipath_dev_err(dd, "%s hardware error\n", msg);
+ if (dd->ipath_flags & IPATH_INITTED) {
+ ipath_set_linkstate(dd, IPATH_IB_LINKDOWN);
+ ipath_setup_pe_setextled(dd,
+ INFINIPATH_IBCS_L_STATE_DOWN,
+ INFINIPATH_IBCS_LT_STATE_DISABLED);
+ ipath_dev_err(dd, "Fatal Hardware Error (freeze "
+ "mode), no longer usable, SN %.16s\n",
+ dd->ipath_serial);
+ isfatal = 1;
+ }
+ *dd->ipath_statusp &= ~IPATH_STATUS_IB_READY;
+ /* mark as having had error */
+ *dd->ipath_statusp |= IPATH_STATUS_HWERROR;
+ /*
+ * mark as not usable, at a minimum until driver
+ * is reloaded, probably until reboot, since no
+ * other reset is possible.
+ */
+ dd->ipath_flags &= ~IPATH_INITTED;
+ } else
+ *msg = 0; /* recovered from all of them */
+
+ if (isfatal && !ipath_diag_inuse && dd->ipath_freezemsg && msg) {
+ /*
+ * for /sys status file ; if no trailing brace is copied,
+ * we'll know it was truncated.
*/
snprintf(dd->ipath_freezemsg, dd->ipath_freezelen,
"{%s}", msg);
@@ -1127,10 +1155,7 @@
INFINIPATH_HWE_RXEMEMPARITYERR_MASK <<
INFINIPATH_HWE_RXEMEMPARITYERR_SHIFT;
- dd->ipath_eep_st_masks[2].errs_to_log =
- INFINIPATH_E_INVALIDADDR | INFINIPATH_E_RESET;
-
-
+ dd->ipath_eep_st_masks[2].errs_to_log = INFINIPATH_E_RESET;
dd->delay_mult = 2; /* SDR, 4X, can't change */
}
@@ -1204,6 +1229,9 @@
u64 val;
int i;
int ret;
+ u16 cmdval;
+
+ pci_read_config_word(dd->pcidev, PCI_COMMAND, &cmdval);
/* Use ERROR so it shows up in logs, etc. */
ipath_dev_err(dd, "Resetting InfiniPath unit %u\n", dd->ipath_unit);
@@ -1231,10 +1259,14 @@
ipath_dev_err(dd, "rewrite of BAR1 failed: %d\n",
r);
/* now re-enable memory access */
+ pci_write_config_word(dd->pcidev, PCI_COMMAND, cmdval);
if ((r = pci_enable_device(dd->pcidev)))
ipath_dev_err(dd, "pci_enable_device failed after "
"reset: %d\n", r);
- /* whether it worked or not, mark as present, again */
+ /*
+ * whether it fully enabled or not, mark as present,
+ * again (but not INITTED)
+ */
dd->ipath_flags |= IPATH_PRESENT;
val = ipath_read_kreg64(dd, dd->ipath_kregs->kr_revision);
if (val == dd->ipath_revision) {
@@ -1273,6 +1305,11 @@
{
u32 __iomem *tidp32 = (u32 __iomem *)tidptr;
unsigned long flags = 0; /* keep gcc quiet */
+ int tidx;
+ spinlock_t *tidlockp;
+
+ if (!dd->ipath_kregbase)
+ return;
if (pa != dd->ipath_tidinvalid) {
if (pa & ((1U << 11) - 1)) {
@@ -1302,14 +1339,22 @@
* call can be done from interrupt level for the port 0 eager TIDs,
* so we have to use irqsave locks.
*/
- spin_lock_irqsave(&dd->ipath_tid_lock, flags);
+ /*
+ * Assumes tidptr always > ipath_egrtidbase
+ * if type == RCVHQ_RCV_TYPE_EAGER.
+ */
+ tidx = tidptr - dd->ipath_egrtidbase;
+
+ tidlockp = (type == RCVHQ_RCV_TYPE_EAGER && tidx < dd->ipath_rcvegrcnt)
+ ? &dd->ipath_kernel_tid_lock : &dd->ipath_user_tid_lock;
+ spin_lock_irqsave(tidlockp, flags);
ipath_write_kreg(dd, dd->ipath_kregs->kr_scratch, 0xfeeddeaf);
- if (dd->ipath_kregbase)
- writel(pa, tidp32);
+ writel(pa, tidp32);
ipath_write_kreg(dd, dd->ipath_kregs->kr_scratch, 0xdeadbeef);
mmiowb();
- spin_unlock_irqrestore(&dd->ipath_tid_lock, flags);
+ spin_unlock_irqrestore(tidlockp, flags);
}
+
/**
* ipath_pe_put_tid_2 - write a TID in chip, Revision 2 or higher
* @dd: the infinipath device
@@ -1325,6 +1370,10 @@
u32 type, unsigned long pa)
{
u32 __iomem *tidp32 = (u32 __iomem *)tidptr;
+ u32 tidx;
+
+ if (!dd->ipath_kregbase)
+ return;
if (pa != dd->ipath_tidinvalid) {
if (pa & ((1U << 11) - 1)) {
@@ -1344,8 +1393,8 @@
else /* for now, always full 4KB page */
pa |= 2 << 29;
}
- if (dd->ipath_kregbase)
- writel(pa, tidp32);
+ tidx = tidptr - dd->ipath_egrtidbase;
+ writel(pa, tidp32);
mmiowb();
}
diff --git a/drivers/infiniband/hw/ipath/ipath_init_chip.c b/drivers/infiniband/hw/ipath/ipath_init_chip.c
index 0db19c1..8d8e572 100644
--- a/drivers/infiniband/hw/ipath/ipath_init_chip.c
+++ b/drivers/infiniband/hw/ipath/ipath_init_chip.c
@@ -319,7 +319,7 @@
else ipath_dbg("%u 2k piobufs @ %p\n",
dd->ipath_piobcnt2k, dd->ipath_pio2kbase);
- spin_lock_init(&dd->ipath_tid_lock);
+ spin_lock_init(&dd->ipath_user_tid_lock);
spin_lock_init(&dd->ipath_sendctrl_lock);
spin_lock_init(&dd->ipath_gpio_lock);
spin_lock_init(&dd->ipath_eep_st_lock);
diff --git a/drivers/infiniband/hw/ipath/ipath_kernel.h b/drivers/infiniband/hw/ipath/ipath_kernel.h
index 56e51cd..8905996 100644
--- a/drivers/infiniband/hw/ipath/ipath_kernel.h
+++ b/drivers/infiniband/hw/ipath/ipath_kernel.h
@@ -407,7 +407,7 @@
u64 __iomem *ipath_egrtidbase;
/* lock to workaround chip bug 9437 and others */
spinlock_t ipath_kernel_tid_lock;
- spinlock_t ipath_tid_lock;
+ spinlock_t ipath_user_tid_lock;
spinlock_t ipath_sendctrl_lock;
/*