ASoC: ad193x: Split SPI and I2C code into different modules
There are a few known (minor) problems with having the support code for both I2C
and SPI in the same module:
* We need to be extra careful to make sure to not build the driver into the
kernel if one of the subsystems is build as a module (Currently only I2C
can be build as a module).
* The module init path error handling is rather ugly. E.g. what should be
done if either the SPI or the I2C driver fails to register? Most drivers
that implement SPI and I2C in the same module currently fallback to
undefined behavior in that case. Splitting the the driver into two
modules, one for each bus, allows the registration of the other bus driver
to continue without problems if one of them fails.
This patch splits the AD193X driver into 3 modules. One core module that
implements the device logic, but is independent of the bus method used. And one
module for SPI and I2C each that registers the drivers and sets up the regmap
struct for the bus.
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/sound/soc/codecs/Kconfig b/sound/soc/codecs/Kconfig
index 983d087a..d7da619 100644
--- a/sound/soc/codecs/Kconfig
+++ b/sound/soc/codecs/Kconfig
@@ -16,7 +16,8 @@
select SND_SOC_AB8500_CODEC if ABX500_CORE
select SND_SOC_AC97_CODEC if SND_SOC_AC97_BUS
select SND_SOC_AD1836 if SPI_MASTER
- select SND_SOC_AD193X if SND_SOC_I2C_AND_SPI
+ select SND_SOC_AD193X_SPI if SPI_MASTER
+ select SND_SOC_AD193X_I2C if I2C
select SND_SOC_AD1980 if SND_SOC_AC97_BUS
select SND_SOC_AD73311
select SND_SOC_ADAU1373 if I2C
@@ -182,6 +183,14 @@
config SND_SOC_AD193X
tristate
+config SND_SOC_AD193X_SPI
+ tristate
+ select SND_SOC_AD193X
+
+config SND_SOC_AD193X_I2C
+ tristate
+ select SND_SOC_AD193X
+
config SND_SOC_AD1980
tristate