pch_uart: Set PCIe bus number using probe parameter
Currently, PCIe bus number is set as fixed value "2".
However, PCIe bus number is not always "2".
This patch sets bus number using probe() parameter.
Signed-off-by: Tomoya MORINAGA <tomoya-linux@dsn.okisemi.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/tty/serial/pch_uart.c b/drivers/tty/serial/pch_uart.c
index 846dfcd..b46218d 100644
--- a/drivers/tty/serial/pch_uart.c
+++ b/drivers/tty/serial/pch_uart.c
@@ -598,7 +598,8 @@
dma_cap_zero(mask);
dma_cap_set(DMA_SLAVE, mask);
- dma_dev = pci_get_bus_and_slot(2, PCI_DEVFN(0xa, 0)); /* Get DMA's dev
+ dma_dev = pci_get_bus_and_slot(priv->pdev->bus->number,
+ PCI_DEVFN(0xa, 0)); /* Get DMA's dev
information */
/* Set Tx DMA */
param = &priv->param_tx;