sky2: fix shutdown synchronization
The logic in sky2_down was incorrect. Receiver could report status
after rx_stop was called.
The steps need to be:
* stop new frames from being transmitted
* shut off transmit/receive logic
* synchronize with NAPI to process status info about transmitter
and receiver
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c
index cc1c8d1..fd7accf 100644
--- a/drivers/net/sky2.c
+++ b/drivers/net/sky2.c
@@ -1815,8 +1815,6 @@
sky2_write32(hw, B0_IMSK, imask);
sky2_read32(hw, B0_IMSK);
- synchronize_irq(hw->pdev->irq);
-
/* Force flow control off */
sky2_write8(hw, SK_REG(port, GMAC_CTRL), GMC_PAUSE_OFF);
@@ -1831,9 +1829,6 @@
ctrl &= ~(GM_GPCR_TX_ENA | GM_GPCR_RX_ENA);
gma_write16(hw, port, GM_GP_CTRL, ctrl);
- /* Make sure no packets are pending */
- napi_synchronize(&hw->napi);
-
sky2_write8(hw, SK_REG(port, GPHY_CTRL), GPC_RST_SET);
/* Workaround shared GMAC reset */
@@ -1864,6 +1859,15 @@
sky2_write8(hw, SK_REG(port, RX_GMF_CTRL_T), GMF_RST_SET);
sky2_write8(hw, SK_REG(port, TX_GMF_CTRL_T), GMF_RST_SET);
+ /* Force any delayed status interrrupt and NAPI */
+ sky2_write32(hw, STAT_LEV_TIMER_CNT, 0);
+ sky2_write32(hw, STAT_TX_TIMER_CNT, 0);
+ sky2_write32(hw, STAT_ISR_TIMER_CNT, 0);
+ sky2_read8(hw, STAT_ISR_TIMER_CTRL);
+
+ synchronize_irq(hw->pdev->irq);
+ napi_synchronize(&hw->napi);
+
sky2_phy_power_down(hw, port);
/* turn off LED's */