mac80211: add IEEE80211_HW_P2P_DEV_ADDR_FOR_INTF
Some devices like the current iwlwifi implementation
require that the P2P interface address match the P2P
Device address (only one P2P interface is supported.)
Add the HW flag IEEE80211_HW_P2P_DEV_ADDR_FOR_INTF
that allows drivers to request that P2P Interfaces
added while a P2P Device is active get the same MAC
address by default.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/include/net/mac80211.h b/include/net/mac80211.h
index edc235c..71f8262 100644
--- a/include/net/mac80211.h
+++ b/include/net/mac80211.h
@@ -1241,6 +1241,10 @@
* queue mapping in order to use different queues (not just one per AC)
* for different virtual interfaces. See the doc section on HW queue
* control for more details.
+ *
+ * @IEEE80211_HW_P2P_DEV_ADDR_FOR_INTF: Use the P2P Device address for any
+ * P2P Interface. This will be honoured even if more than one interface
+ * is supported.
*/
enum ieee80211_hw_flags {
IEEE80211_HW_HAS_RATE_CONTROL = 1<<0,
@@ -1268,6 +1272,7 @@
IEEE80211_HW_AP_LINK_PS = 1<<22,
IEEE80211_HW_TX_AMPDU_SETUP_IN_HW = 1<<23,
IEEE80211_HW_SCAN_WHILE_IDLE = 1<<24,
+ IEEE80211_HW_P2P_DEV_ADDR_FOR_INTF = 1<<25,
};
/**