libata: remove no longer needed pata_winbond driver
Winbond W83759A controller is fully supported by pata_legacy driver
so remove no longer needed pata_winbond driver.
Leave PATA_WINBOND_VLB config option for compatibility reasons
and teach pata_legacy to preserve the old behavior of pata_winbond
driver.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
diff --git a/drivers/ata/pata_legacy.c b/drivers/ata/pata_legacy.c
index 9df1ff7..eaf1941 100644
--- a/drivers/ata/pata_legacy.c
+++ b/drivers/ata/pata_legacy.c
@@ -44,6 +44,9 @@
* Specific support is included for the ht6560a/ht6560b/opti82c611a/
* opti82c465mv/promise 20230c/20630/qdi65x0/winbond83759A
*
+ * Support for the Winbond 83759A when operating in advanced mode.
+ * Multichip mode is not currently supported.
+ *
* Use the autospeed and pio_mask options with:
* Appian ADI/2 aka CLPD7220 or AIC25VL01.
* Use the jumpers, autospeed and set pio_mask to the mode on the jumpers with
@@ -135,12 +138,18 @@
static int opti82c611a; /* Opti82c611A on primary 1, sec 2, both 3 */
static int opti82c46x; /* Opti 82c465MV present(pri/sec autodetect) */
static int qdi; /* Set to probe QDI controllers */
-static int winbond; /* Set to probe Winbond controllers,
- give I/O port if non standard */
static int autospeed; /* Chip present which snoops speed changes */
static int pio_mask = ATA_PIO4; /* PIO range for autospeed devices */
static int iordy_mask = 0xFFFFFFFF; /* Use iordy if available */
+#ifdef PATA_WINBOND_VLB_MODULE
+static int winbond = 1; /* Set to probe Winbond controllers,
+ give I/O port if non standard */
+#else
+static int winbond; /* Set to probe Winbond controllers,
+ give I/O port if non standard */
+#endif
+
/**
* legacy_probe_add - Add interface to probe list
* @port: Controller port
@@ -1297,6 +1306,7 @@
MODULE_DESCRIPTION("low-level driver for legacy ATA");
MODULE_LICENSE("GPL");
MODULE_VERSION(DRV_VERSION);
+MODULE_ALIAS("pata_winbond");
module_param(probe_all, int, 0);
module_param(autospeed, int, 0);
@@ -1305,6 +1315,7 @@
module_param(opti82c611a, int, 0);
module_param(opti82c46x, int, 0);
module_param(qdi, int, 0);
+module_param(winbond, int, 0);
module_param(pio_mask, int, 0);
module_param(iordy_mask, int, 0);