V4L/DVB (4042): Documentation: whitespace cleanup
Signed-off-by: Michael Krufky <mkrufky@linuxtv.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@infradead.org>
diff --git a/Documentation/video4linux/ov511.txt b/Documentation/video4linux/ov511.txt
index 142741e..79af610 100644
--- a/Documentation/video4linux/ov511.txt
+++ b/Documentation/video4linux/ov511.txt
@@ -81,7 +81,7 @@
TYPE: integer (Boolean)
DEFAULT: 1
DESC: Brightness is normally under automatic control and can't be set
- manually by the video app. Set to 0 for manual control.
+ manually by the video app. Set to 0 for manual control.
NAME: autogain
TYPE: integer (Boolean)
@@ -97,13 +97,13 @@
TYPE: integer (0-6)
DEFAULT: 3
DESC: Sets the threshold for printing debug messages. The higher the value,
- the more is printed. The levels are cumulative, and are as follows:
- 0=no debug messages
- 1=init/detection/unload and other significant messages
- 2=some warning messages
- 3=config/control function calls
- 4=most function calls and data parsing messages
- 5=highly repetitive mesgs
+ the more is printed. The levels are cumulative, and are as follows:
+ 0=no debug messages
+ 1=init/detection/unload and other significant messages
+ 2=some warning messages
+ 3=config/control function calls
+ 4=most function calls and data parsing messages
+ 5=highly repetitive mesgs
NAME: snapshot
TYPE: integer (Boolean)
@@ -116,24 +116,24 @@
TYPE: integer (1-4 for OV511, 1-31 for OV511+)
DEFAULT: 1
DESC: Number of cameras allowed to stream simultaneously on a single bus.
- Values higher than 1 reduce the data rate of each camera, allowing two
- or more to be used at once. If you have a complicated setup involving
- both OV511 and OV511+ cameras, trial-and-error may be necessary for
- finding the optimum setting.
+ Values higher than 1 reduce the data rate of each camera, allowing two
+ or more to be used at once. If you have a complicated setup involving
+ both OV511 and OV511+ cameras, trial-and-error may be necessary for
+ finding the optimum setting.
NAME: compress
TYPE: integer (Boolean)
DEFAULT: 0
DESC: Set this to 1 to turn on the camera's compression engine. This can
- potentially increase the frame rate at the expense of quality, if you
- have a fast CPU. You must load the proper compression module for your
- camera before starting your application (ov511_decomp or ov518_decomp).
+ potentially increase the frame rate at the expense of quality, if you
+ have a fast CPU. You must load the proper compression module for your
+ camera before starting your application (ov511_decomp or ov518_decomp).
NAME: testpat
TYPE: integer (Boolean)
DEFAULT: 0
DESC: This configures the camera's sensor to transmit a colored test-pattern
- instead of an image. This does not work correctly yet.
+ instead of an image. This does not work correctly yet.
NAME: dumppix
TYPE: integer (0-2)