| Laser Sensor Device Tree Bindings. |
| ======================================== |
| |
| Boards with the Laser Sensor connected to CCI shall have the following |
| properties: |
| |
| Required node properties: |
| - cell-index: cci hardware core index |
| - compatible: |
| - "st,stmvl53l0" : STMiecroelectronics VL53L0 Laser sensor. |
| - reg : offset and length of the register set for the device |
| - qcom, cci-master: cci master the sensor connected to |
| - cam_cci-supply : cci voltage regulator used |
| - cam_laser-supply: laser sensor voltage regulator |
| - qcom,cam-vreg-name: voltage regulators name |
| - qcom, cam-vreg-min-voltage: specify minimum voltage level for |
| regulators used |
| - qcom, cam-vreg-max-voltage: specify maximum voltage level for |
| regulators used |
| - pinctrl-names : should specify the pin control groups followed by |
| the definition of each group |
| stm,irq-gpio : irq gpio which is to provide interrupts to host. |
| - gpios : should contain phandle to gpio controller node and array of |
| #gpio-cells specifying specific gpio (controller specific) |
| - qcom,gpio-req-tbl-num : contains index to gpios specific to the sensor |
| - qcom,gpio-req-tbl-flags : should contain direction of gpios present in |
| qcom,gpio-req-tbl-num property (in the same order) |
| - qcom,gpio-req-tbl-label : should contain name of gpios present in |
| qcom,gpio-req-tbl-num property (in the same order) |