[SCSI] qla4xxx: Added support for ISP83XX
Signed-off-by: Poornima Vonti <poornima.vonti@qlogic.com>
Signed-off-by: Vikas Chaudhary <vikas.chaudhary@qlogic.com>
Reviewed-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/drivers/scsi/qla4xxx/ql4_init.c b/drivers/scsi/qla4xxx/ql4_init.c
index 6bc983d..a1881d0 100644
--- a/drivers/scsi/qla4xxx/ql4_init.c
+++ b/drivers/scsi/qla4xxx/ql4_init.c
@@ -107,6 +107,13 @@
(unsigned long __iomem *)&ha->qla4_82xx_reg->rsp_q_in);
writel(0,
(unsigned long __iomem *)&ha->qla4_82xx_reg->rsp_q_out);
+ } else if (is_qla8032(ha)) {
+ writel(0,
+ (unsigned long __iomem *)&ha->qla4_83xx_reg->req_q_in);
+ writel(0,
+ (unsigned long __iomem *)&ha->qla4_83xx_reg->rsp_q_in);
+ writel(0,
+ (unsigned long __iomem *)&ha->qla4_83xx_reg->rsp_q_out);
} else {
/*
* Initialize DMA Shadow registers. The firmware is really
@@ -524,7 +531,7 @@
/* For 82xx, stop firmware before initializing because if BIOS
* has previously initialized firmware, then driver's initialize
* firmware will fail. */
- if (is_qla8022(ha))
+ if (is_qla80XX(ha))
qla4_8xxx_stop_firmware(ha);
ql4_printk(KERN_INFO, ha, "Initializing firmware..\n");
@@ -537,7 +544,7 @@
if (!qla4xxx_fw_ready(ha))
return status;
- if (is_qla8022(ha) && !test_bit(AF_INIT_DONE, &ha->flags))
+ if (is_qla80XX(ha) && !test_bit(AF_INIT_DONE, &ha->flags))
qla4xxx_alloc_fw_dump(ha);
return qla4xxx_get_firmware_status(ha);
@@ -946,9 +953,9 @@
set_bit(AF_ONLINE, &ha->flags);
exit_init_hba:
- if (is_qla8022(ha) && (status == QLA_ERROR)) {
+ if (is_qla80XX(ha) && (status == QLA_ERROR)) {
/* Since interrupts are registered in start_firmware for
- * 82xx, release them here if initialize_adapter fails */
+ * 80XX, release them here if initialize_adapter fails */
qla4xxx_free_irqs(ha);
}