net: dsa: Initialize ds->enabled_port_mask and ds->phys_mii_mask
Some drivers rely on these two bitmasks to contain the correct values
for them to successfully probe and initialize at drv->setup() time,
calculate correct values to put in both masks as early as possible in
dsa_get_ports_dn().
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/net/dsa/dsa2.c b/net/dsa/dsa2.c
index 80dfe08d..921a36f 100644
--- a/net/dsa/dsa2.c
+++ b/net/dsa/dsa2.c
@@ -283,6 +283,7 @@
if (ds->ports[index].netdev) {
dsa_slave_destroy(ds->ports[index].netdev);
ds->ports[index].netdev = NULL;
+ ds->enabled_port_mask &= ~(1 << index);
}
}
@@ -292,6 +293,13 @@
u32 index;
int err;
+ /* Initialize ds->phys_mii_mask before registering the slave MDIO bus
+ * driver and before drv->setup() has run, since the switch drivers and
+ * the slave MDIO bus driver rely on these values for probing PHY
+ * devices or not
+ */
+ ds->phys_mii_mask = ds->enabled_port_mask;
+
err = ds->drv->setup(ds);
if (err < 0)
return err;
@@ -511,6 +519,13 @@
return -EINVAL;
ds->ports[reg].dn = port;
+
+ /* Initialize enabled_port_mask now for drv->setup()
+ * to have access to a correct value, just like what
+ * net/dsa/dsa.c::dsa_switch_setup_one does.
+ */
+ if (!dsa_port_is_cpu(port))
+ ds->enabled_port_mask |= 1 << reg;
}
return 0;